3Installation
BIn case the information which are given in the user manual are not taken into account, manufacturer will not assume any liability for this.
Points to be paid attention to when the relocation of the cooler/freezer
1.Your cooler/freezer should be unplugged. Before transportation of your cooler/ freezer, it should be emptied and cleaned.
2.Before it is
3.Original packaging and foam materials should be kept for future transportations or moving.
Before you start the cooler/ freezer,
Check the following before you start to use your cooler/freezer:
1.Attach 2 plastic wedges as illustrated below. Plastic wedges are intended to keep the distance which will ensure the air circulation between your cooler/freezer and the wall. (The picture is drawn up as a representation and it is not identical with your product.)
2.Clean the interior of the cooler/freezer as recommended in the “Maintenance and cleaning” section.
3.Connect the plug of the cooler/freezer to the wall socket. When the fridge door is opened, fridge internal lamp will turn on.
4.When the compressor starts to operate, a sound will be heard. The liquid and gases sealed within the refrigeration system may also give rise to noise, even if the compressor is not running and this is quite normal.
5.Front edges of the cooler/freezer may feel warm. This is normal. These areas are designed to be warm to avoid condensation.
Electrical connection
Connect your product to a grounded socket which is being protected by a fuse with the appropriate capacity.
Important:
The connection must be in compliance with national regulations.
•The power plug must be easily accessible after installation.
•Electrical safety of your cooler/freezer shall be guaranteed only if the earth system in your house complies with standards.
8
EN