Beko CFD 7914 manual Adjustment of feet avoids excessive vibration and noise

BEKO declines to accept any liability should the instructions not be followed.

INSTALLATION INSTRUCTIONS 1.Fitted the two plastic wall spacers

supplied onto the condenser at the back of the appliance by rotating 1/4 turn.

2.Locate the appliance on a smooth surface.

3.To ensure it is standing upright adjust the two front feet by turning clockwise or anti-clockwise, until it is in firm contact with the floor. Correct

adjustment of feet avoids excessive vibration and noise.

4.A special receptacle is supplied to store the mains plug during transit. The receptacle is fixed at the back of the cabinet on the side of the compressor. Gently remove the plug from the receptacle. Never pull the mains cord, you may damage the appliance. In case of transportation, ensure you locate the

plug in the receptacle provided to avoid transit damage.

5.The space in the room where the appliance is installed must

not be smaller than 10 cubic metres. 6.Fit the front grille supplied with your

appliance as shown in the diagram.

8

EN