Care and maintenance
How to dismantle parts
NOTE
•Dismantling is done in the reverse sequence of assembly.
Be sure to unplug the power plug before dismantling and assembly. Never apply severe force to dismantle parts. Parts may be damaged.
Freezer
compartment
lamp
Dispenser lamp
Freezer
compartment
shelf
Door rack and support
Separate the lamp by pulling it out (➂) while slightly striking (➀) and rotating (➁) the lamp cover.
Turn the bulb counterclockwise. Max. 40 W bulb for refrigerator is used and can be purchased at a service center.
Seperate the lamp by pulling it out, and then remove the lamp. Max. 15 W bulb for refrigerator is used and can be purchased at a service center.
To remove a shelf, lift the left part of the shelf a bit, push it to the direction ( ), lift the right part to the diretion ( ), and take it out.
Lift the door rack holding both sides ( ) and pull it out to ( ) direction.
32
EXPRESS/JETFRZDISPENSERFREEZERREFRIGERATERFILTER/LIGHTLOCK
1 | 2 |
Ice storage bin
After dispenser
is used
Hold the ice storage bin as shown in the right | 2 | 1 |
figure and pull it out ( ) while slightly lifting it | ||
( ). | ||
It is recommended not to dismantle the ice |
| |
storage bin unless it is necessary. |
|
Be sure to use both hands when removing the ice storage bin, so as not to drop it on the floor.
If the ice storage bin does not fit well, slightly rotate the rotating device.
The water collector has no
23