DISASSEMBLY INSTRUCTIONS
IMPORTANT NOTES:
UNIT MUST BE DISCONNECTED FROM ELECTRICAL OUTLET WHEN MAKING REPAIRS,
THE CAPACITOR SHOULD BE DISCHARGED BY USING INSULATED WIRE - I.E. TEST PROBE CONNECTED TO
WHEN RECONNECTING THE WIRE LEADS TO ANY PART, MAKE SURE THE WIRING CONNE- CTIONS AND LEAD COLORS ARE CORRECTLY MATCHED ACCORDING TO THE OVERALL CIR- CUIT DIAGRAM. (ESPECIALLY SWITCHES AND HIGH VOLTAGE CIRCUIT.)
A.REMOVING POWER AND CONTROL CIRCUIT BOARD (Figures 1, 2 and 3)
(1)Remove a screw securing the control panel assembly to the oven cavity.
(2)Remove the control panel with pushing it upward.
(3)Remove the connector (CN1) and wire leads (Relay6) from the circuit board.
Control Panel
Screw
Power Transformer
Relay 7
(Relay 7)
(CN1)
(4) Remove 2 screws securing the circuit board.
Circuit Board
Figure 2
(5)Remove the FPC connector from the terminal socket following “HOW TO REMOVE THE FPC CONNECTOR” on the next page.
(6)Remove the circuit board from the control bracket carefully.
Control Bracket
FPC Connector(S1)
Circuit Board
Figure 1 | Figure 3 |