Opening for external temperature sensor | Opening for external temperature sensor |
Model LGUex 1500 | Model LGex 3410 |
| Remove upper drawer before beginning work. |
1. Drill marked section on the back of the appliance.
2. Pull out strain relief device (bot- tom left of interior container).
3.Feed sensor through opening and secure sensor cable with strain relief device.
Important!
Position the sensor at the top of the interior container. The sen- sor must not come into contact with objects so that only the air temperature is measured.
Important!
4. Close the sensor cable opening at the back of the appliance with the sealant provided.
The condenser must be unscrewed to make the sensor cable opening accessible.
1. Unscrew condenser screws (6 pcs.) and fold out condenser at an angle.
Important!
Make sure that no pipes are bent.
2. Drill marked section at the back of 
appliance.
Important!
Only drill the outer wall of the housing.
Do not drill too far.
3. Pull out strain relief device (top left of interior container).
4. Feedsensorthroughopening and secure sensor cable with strain relief device.
Important!
Position the sensor at the top of the interior container. The sen- sor must not come into contact with objects so that only the air temperature is measured.
Important!
5. Close the sensor cable opening at the back of the appliance with the sealant provided.
6. Screw condenser back on.
20