Operation
Operating and
Control Elements - Figure 5
Figure 5
1Temperature display
2Temperature setting buttons
3Alarm Off button
4Childproof lock symbol
5On/Off button
6Appliance is defrosting
Turning the Appliance
On and Off - Figure 6
Clean the appliance before turning it on for the first time. See Cleaning.
Connect the appliance to the dedicated outlet.
•To turn the appliance on: Press the On/Off but- ton until the display lights up.
•To turn the appliance off: Keep the On/Off but- ton pressed for three seconds so that the tem- perature display goes out.
Figure 6
Setting the Temperature - Figure 7
To reduce the temperature: Press the Down but-
ton.
To increase the temperature: Press the Up button.
-While you are entering the temperature, the set temperature will flash on the display.
-You can change the settings in increments of 1°F (1°C) by briefly pressing the button again. The electronic controls will switch over automati- cally about five seconds after the last time you pressed the button. The actual temperature will display.
Figure 7
If F3, F4 or HE appears in the display, the appli- ance has a fault. Contact your nearest customer service representative.
Audible Warning Signal - Figure 8
-The audible warning signal sounds when the door is open for longer than about 180 seconds. The audible warning device is turned off by pressing the Alarm button.
-The audible warning signal sounds when the interior gets too warm. The temperature display will also flash. The audible warning device is turned
off by pressing the Alarm button. The temperature display will continue to flash until the cause of the alarm has been rectified.
Figure 8
11