Rangemaster RDW459FI/SF manual To select the ‘tablets’ function, To cancel the ‘tablets’ function

Fig.2-19

Additional options button

To select the ‘tablets’ function:

1.Open the door.

2.Select the programme and then press the additional options button (Fig.2-19)until the tablets indicator [] lights.

3.Press the Start/Reset button (Fig.2-20)and close the door. The dishwasher will start immediately.

			To cancel the ‘tablets’ function:
			Follow the ‘Cancelling or modifying a cycle’ instructions.
			If you decide to switch to the use of a standard detergent
			system we advise that you:
Fig.2-20	Start/reset button
		1.		Refill both the salt and rinse aid compartments.
		2.		Switch the water hardness setting to the highest
				possible position and run for three normal cycles
		3.		without a load.
				Readjust the water hardness setting again according
				to the conditions for your region. For more information
				please refer to your instruction manual.

Upper rack wash

This function allows the dishwasher to wash dishes using only the upper rack. This will allow you to save on water and energy consumption if there are not enough dishes for a full load.

To select upper rack wash:

1.	Open the door. Select the programme and then press
	the additional options button until the upper rack wash
	[ ] indicator lights (Fig.2-19).
2.	Press the Start/Reset button (Fig.2-20)and close the
	door, the dishwasher will start immediately.

To cancel the upper rack wash:

Follow the ‘Cancelling or modifying a cycle’ instructions.

Note: Please keep in mind that the amount of detergent should also be adapted to the load.

10