Connecting the water outlet hose
Connect the outlet hose (without bending it) to a drain duct with a minimum diameter of 4 cm. Alternatively, rest it over a sink or tub; the free end of the hose should not remain immersed in water.
AThe special plastic
elbow* makes it easier to
find the best layout: fix
the elbow to the wall
securely in order to
prevent the outlet hose
from moving and spilling
the dirty water.
The part of the hose marked with the letter A
should be between 40 and 100 cm above the ground (see figure).
We advise against the use of hose extensions.
Electrical connection
Before inserting the plug into the electrical socket, make sure that:
•the socket is earthed and complies with current regulations;
•the socket can withstand the maximum load of the appliance, which is indicated on the data plate located on the inside of the door (see Description of the appliance);
•the power supply voltage falls within the values indicated on the data plate on the inside of the door;
•the socket is compatible with the plug of the appliance. If this is not the case, ask an authorised technician to replace the plug (see Assistance); do not use extension cables or multiple sockets.
Once the appliance has been installed, the power supply cable and the electrical socket should be easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged, it must be replaced by the manufacturer or its Technical Assistance Service in order to prevent all potential hazards. (See Assistance)
The Company shall not be held responsible for any incidents that occur if these regulations are not observed.
Advice regarding the first wash cycle
EN
After the appliance has been installed, immediately before running the first wash cycle, completely fill the salt dispenser with water and add approximately 2 kg of salt (see Rinse aid and refined salt). The water may overflow: this is normal and is not a cause for concern. It is also normal that the LOW SALT* indicator light continues to flash for a few cycles after the salt has been loaded.
Technical data
|
|
|
| |
Dimensions | width 60 cm | |||
height 85 cm | ||||
|
|
| depth 60 cm | |
|
|
| ||
Capacity | 12 standard | |||
|
|
| ||
Water supply | 0,03 ÷ 1MPa (0.3 ÷ 10 bar) | |||
pressure | 4.3 psi – 145 psi | |||
|
| |||
Power supply | See appliance data plate | |||
voltage | ||||
| ||||
|
| |||
Total absorbed | See appliance data plate | |||
power |
| |||
Fuse | See appliance data plate | |||
|
|
|
| |
|
|
| This dishwasher conforms to | |
|
|
| the following European | |
|
|
| Community Directives: | |
|
|
| ||
|
|
| (Low Voltage) and subsequent | |
|
|
| modifications | |
|
|
| ||
|
|
| (Electromagnetic Compatibility) | |
|
|
| and subsequent modifications | |
|
|
| ||
|
|
| ||
|
|
| and Electronic Equipment | |
|
|
| ||
|
|
| (WEEE) | |
|
|
| ||
|
|
|
| |
* Only available in selected models.
3