Indesit DIS 04 Advice regarding the first wash cycle, Connecting the water outlet hose

Connecting the water outlet hose

Connect the outlet hose (without bending it) to a drain duct with a minimum diameter of 4 cm. Alternatively, rest it over a sink or tub; the free end of the hose should not remain immersed in water.

Anti-condensation strip*

After installing the dishwasher, open the door and stick	EN
the adhesive transparent strip under the wooden shelf in
order to protect it from any condensation which may
form.

Advice regarding the first wash cycle

A

(see figure).

The special plastic elbow* makes it easier to find the best layout: fix the elbow to the wall securely in order to prevent the outlet hose from moving and spilling the dirty water.

The part of the hose marked with the letter A should be between 40 and 100 cm above the ground

After the appliance has been installed, immediately before running the first wash cycle, completely fill the salt dispenser with water and add only then approximately 1 kg of salt (see chapter entitled Rinse aid and refined salt). The water may overflow: this is normal and is not a cause for concern. Select the water hardness value (see chapter entitled Rinse aid and refined salt). - After the salt has been poured into the machine, the LOW SALT indicator light* switches off.

If the salt container is not filled, the water softener and the heating element may be damaged as a result.

We advise against the use of hose extensions.

Electrical connection

Before inserting the plug into the electrical socket, make sure that:

•The socket is earthed and complies with current regulations.

•The socket can withstand the maximum load of the appliance, which is indicated on the data plate located on the inside of the door (see chapter entitled Description of the appliance).

•The power supply voltage falls within the values indicated on the data plate on the inside of the door.

•The socket is compatible with the plug of the appliance. If this is not the case, ask an authorised technician to replace the plug (see Assistance); do not use extension cables or multiple sockets.

Once the appliance has been installed, the power supply cable and the electrical socket should be easily accessible.

The cable should not be bent or compressed.

If the power supply cable is damaged, it must be re- placed by the manufacturer or its Technical Assistance Service in order to prevent all potential hazards. (See As- sistance)

The Company shall not be held responsible for any incidents that occur if these regulations are not observed.

Technical data

Dimensions	width 44.5 cm
	height 82 cm
	depth 57 cm
Capacity	10 standard place-settings
Water supply	0,05 ÷ 1MPa (0.5 ÷ 10 bar)
pressure	7,25 – 145 psi
Power supply	See appliance data plate
voltage
Total absorbed	See appliance data plate
power
Fuse	See appliance data plate
	This dishwasher conforms to
	the following European
	Community Directives:
	-2006/95/EEC dated
	16/01/2007
	(Low Voltage) and subsequent
	modifications
	-89/336/EEC dated 03/05/89
	(Electromagnetic Compatibility)
	and subsequent modifications
	-97/17/EC (Labelling)
	-2002/96/ CE (Waste Electrical
	and Electronic Equipment
	WEEE)

*Only available in selected models.

3