Indesit DIF 1614 Advice regarding the first wash cycle, Electrical connection

Electrical connection

Before inserting the plug into the electrical socket, make sure that:

•The socket is earthed and complies with current regulations.

•The socket can withstand the maximum load of the appliance, which is indicated on the data plate located on the inside of the door (see chapter entitled Description of the appliance).

•The power supply voltage falls within the values indicated on the data plate on the inside of the door.

•The socket is compatible with the plug of the appliance. If this is not the case, ask an authorised technician to replace the plug (see Assistance); do not use extension cables or multiple sockets.

Once the appliance has been installed, the power supply cable and the electrical socket should be easily accessible.

The cable should not be bent or compressed.

If the power supply cable is damaged, it must be re- placed by the manufacturer or its Technical Assistance Service in order to prevent all potential hazards. (See After Sales Service)

The Company shall not be held responsible for any incidents that occur if these regulations are not observed.

Anti-condensation strip*
	EN
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order
to protect it from any condensation which may form.
Advice regarding the first wash cycle
After the appliance has been installed, immediately before
running the first wash cycle, completely fill the salt
dispenser with water and add only then approximately 1 kg
of salt (see chapter entitled Rinse aid and refined salt). The
water may overflow: this is normal and is not a cause for
concern. Select the water hardness value (see chapter
entitled Rinse aid and refined salt). - After the salt has been
poured into the machine, the LOW SALT indicator light*
switches off.
If the salt container is not filled, the water softener and
the heating element may be damaged as a result.

Technical data

width 59.5 cm

Dimensions height 82 cm depth 57 cm

Capacity	14 standard place-settings
Water supply	0,05 ÷ 1MPa (0.5 ÷ 10 bar)
pressure	7,25 – 145 psi
Power supply	See appliance data plate
voltage
Total absorbed	See appliance data plate
power
Fuse	See appliance data plate
	This dishwasher conforms to the
	following European Community
	Directives:
	-2006/95/EC (Low Voltage)
	-2004/108/EC (Electromagnetic
	Compatibility)
	-2005/32/EC (Comm. Reg.
	1275/2008) (Ecodesign)
	-97/17/EC (Labelling)
	-2002/96/EC (WEEE)

ECODESIGN REGULATION

ECO wash cycle is the standard cycle to which the energy label data refers; this cycle can be used to wash crockery with a normal soil level and is the most efficient in terms of energy and water consumption for this type of crockery. To reduce consumption even further, only run the dishwasher when it is full.

Standby consumption: Left-on mode consumption: 3 W – Off mode consumption: 1,3 W Consumption data table for the main cycles

	Standard conditions*			User conditions**
	Energy consumption	Water consumption	Duration	Energy consumption	Water consumption	Duration
	(kWh/cycle)	(l/cycle)	(min/cycle)	(kWh/cycle)	(l/cycle)	(min/cycle)
INTENSIVE	1,65	16	150	1,45	15	135
NORMAL	1,35	16	120	1,20	15	110

*Cycle data refers to the values recorded in a laboratory, in accordance with European standard EN 50242.

**Data is obtained by recording values when the appliance is operational and loaded with user crockery.

3