Indesit KD3C1/G manual Care and Cleaning

Care and Cleaning

Ceramic hob

Grill

To reduce the amount of cleaning always ensure that the hob and cooking utensils are clean and dry before use. Regular use of cleaner conditioner is recommended for proper care and protection of the hob surface. Apply conditioner before using the hob for the first time. It contains a mild cleaning agent, so that subsequent applications may clean off soil and apply a protective film at the same time. For stubborn stains or heavy soiling use any of the following materials, and finish off with conditioner.

1.Cif, non-scratch scouring cream.

2.Liquid Gumption Kitchen Cleanser.

3.Special Powder Cleanser.

Powder Cleanser – Mineral deposits that are present in hard water, and some foods, may cause ‘discolourations’ that appear in the form of grey or brown stains. The stains sometimes appear to be in or under the glass surface. If there are some persistent stains after using any of the other recommended cleaning materials, powder cleanser may be applied, following the manufacturers instructions. Do not use abrasive cleaners or the powder cleanser on the painted metal framework. Cleaner Conditioner – Regular use of the conditioner will make the surface easier to clean thus ensuring that years of heavy abrasive cleaning do not progressively dull the surface.

Remove the grill pan and the wire grid food support, it is best to wash these items immediately after use to prevent stains from being burnt on when used again. Wipe out the Grill compartment, use a fine steel wool soap pad to remove stubborn stains from the grill runners and the floor of the compartment. Wipe over the control panel with a damp cloth and polish with a dry cloth.

Control Panel	Do not use cream cleaners, oven cleaners or aerosols, scouring pads or abrasive powder for
	cleaning the plastic knobs as damage will occur.
Decorative Trims	It is advisable to clean the decorative trims regularly to prevent any build up of soiling. The
	recommended method of cleaning is to wipe over the trims with a soft cloth wrung out in warm
	water or mild non-abrasive cleaner. (If in doubt try the cleaner on a small area of trim which is not
	noticeable in normal use). Then, after wiping with a cloth wrung out in clear water, dry with a soft
	clean cloth.
Doors	Wipe over the outer door glass panels with a cloth wrung out in warm soapy water, then after
	wiping with a cloth wrung out in clear water, dry with a soft clean cloth. Ensure that glass doors
	are not subjected to any sharp mechanical blows.
	Glass Inner Door Panel (where fitted) – open the door fully and unscrew the two screws securing
	the glass panel, taking care not to allow the glass to fall. The glass panel may now be washed at
	the sink. Stubborn stains can be removed by using a fine steel wool soap pad. Ensure the glass
	panel is not subjected to any sharp mechanical blows. Take particular care not to damage the
	inner surface which is coated with a heat reflective layer. After cleaning, rinse and dry with a soft
	cloth. For slight soiling the inner glass panel may be cleaned, while still warm, without removing it
	from the door.
	Warning: Oven must not be operated with inner door glass removed.
	Take care during cleaning not to damage or distort the door seals. Do not lift the door seal from
	the oven chassis, if necessary remove the seal by carefully unhooking the corner clips.
	Take care that the rating label edges are not lifted during cleaning, and furthermore that the
	lettering is not blurred or removed.

Ovens

Oven Shelf Supports

Oven Lamp Replacement

Remove the rod shelves and grill pan. Use a fine steel wool soap pad to remove stubborn stains from the rod shelves, grill pan and the floor of the oven.

The shelf supports are removable and dishwasher safe.

To remove hold the support at the front and pull away from the oven side, this can then be cleaned in a sink or a dishwasher. When removed it allows access to the oven side, which can be cleaned with warm soapy water.

To refit the support, insert the longer leg into the rear fixing hole and push in the front leg.

Open the oven door and remove the rod shelves. Using a suitable cloth to protect the fingers grip the light glass dome, unscrew anti-clockwise and lift. Reach into the aperture with fingers, and unscrew the lamp anticlockwise. Fit replacement lamp (25W 300°C rated SES), refit dome.

WARNING: To avoid electric shocks - please ensure that the electricity supply to the appliance is switched off and the appliance is fully cold, before removing the lamp lens.

21