Installation of the cooker, Gas connection

Installation

The following instructions should be read by a qualified technician to ensure that the appliance is installed, regulated and technically serviced correctly in compliance with current regulations.

Important: remember to unplug the appliance from the mains before regulating the appliance or carrying out any maintenance work.

Positioning

Important: this unit may be installed and used only in permanently ventilated rooms according to the British Standards Codes Of Practice: B.S. 6172/B.S. 5440, Par. 2 and B.S. 6891 Current Editions.The following requirements must be observed:

a)The cooker should not be installed in a bed sitting room with a volume of less than 20m3. If it is installed in a room of volume less than 5m3 an air vent of effective area of 110cm2 is required, if it is installed in a room of volume between 5m3 and 10m3 a supplementary airvent area of 50cm2 is required, if the volume exceeds 11m3 no airvent is required.However, if the room has a door or a window which opens directly to the outside no air vent is required even when the volume is between 5m3 and 11m3.

b)During prolonged use of the appliance you may consider it necessary to open a window to the outside to improve ventilation.

c)If there are other fuel burning appliances in the same room, B.S.5440 Part 2 Current Edition, should, be consulted to determine the requisite air vent requirements.

Levelling your appliance (only on a few models)

Your cooker is supplied with feet for levelling the appliance. If necessary, these feet can be screwed into the housings in the corners of the cooker base.

Installation of the cooker

The cooker is prepared with protection degree against excessive heating of type X, the appliance can therefore be installed next to cabinets, provided the height does not exceed that of the hob. If the cooker is placed touching walls or sides of neighbouring cabinets, these must be capable of withstanding a temperature rise of 50°C above room tempe- rature. For a correct installation of the cooker the following precautions must be followed:

a)The cooker may be located in a kitchen, a kitonen/diner or bed sitting room, but not in a bathroom or shower room.

b)The furniture units next to the cooker, that is higher than the working boards, must be placed at least 110mm from the edge of the board. Curtains must not be fitted immediately behind the cooker or within 110 mm. of the sides of the cooker.

c)The hoods must be installed according to the requirements in the hood handbook.

d)Wall cabinets may be fitted in line with the sides of the base units, providing that the lower edge of the wall cabinet is a minimum of 420 mm.above the worktop.The minimum distance combustible material kitchen units can be fitted directly above the worktop is 700 mm (Fig. A).

e)The wall in contact with the back of the cooker must be of flameproof material.

f)The cooker is fitted with a safety chain that must be attached to a hook, secured to the wall behind the appliance.

Note: some models can have their gas connection inverted. It is important to make sure the safety chain is always situated on the side which corresponds to the hose holder (Fig. B).

HOOD

	Min. 600 mm.	min. 650 mm. with hood min. 700 mm. without hood
Min. 420 mm.	Min. 420 mm.	min. 650 mm. with hood min. 700 mm. without hood

Mounting the legs (only on a few models)

Press-fit legs are supplied which fit under the base of your cooker.

Fig. A	Fig. B
Gas connection

The cooker should be connected to the gas-supply by a corgi registered installer. During installation of this product it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenience of any subsequent removal or servicing. Connection of the appliance to the gas mains or liquid gas must be carried out according to the prescribed regulation in force, and only after it is ascertained that it is adaptable to the type of gas to be used. If not, follow the instructions indicated in the paragraph headed “Adaptation to different gas types”. In the case of connection to liquid gas, by tank, use pressure regulators that conform to the regulation in force.The gas supply must be connected to the left of the appliance. Be sure that the hose does not pass through the rear of the cooker touching hot parts.

K 642 V/G, K 642 VS/G specifications

Indesit K 642 VS/G and K 642 V/G are two highly sought-after models in the world of gas cookers, known for their reliability and performance. These cookers embody a blend of practicality and modern design, making them a perfect addition to any kitchen.

One of the main features of the Indesit K 642 VS/G and K 642 V/G models is their four gas burners, which offer various cooking options to suit different culinary needs. The burners come in different sizes, allowing users to select the ideal flame for their pots and pans. This feature enhances cooking efficiency, enabling rapid boiling, simmering, and frying.

Another appealing characteristic is the enamelled surface of the cooktops. This not only adds a sleek look to the kitchen but also ensures easy cleaning. The smooth surface allows for quick wipe-downs and maintenance, vital for those with a busy lifestyle or who enjoy cooking regularly.

The integrated ignition system is another essential technology present in these models. With a simple push and turn of the knobs, users can ignite the burners without needing matches or a lighter, adding convenience and safety to the cooking experience. Additionally, the safety features include a flame failure device that automatically shuts off the gas supply if a flame goes out, preventing potential hazards.

Both models also feature an oven with a generous capacity, ideal for baking, roasting, and grilling. The oven boasts various functions to support diverse cooking methods, including a traditional static mode for baking and a grill option for finishing off dishes. The stylish glass door allows users to monitor their dishes without opening the oven, thus retaining heat.

Moreover, the K 642 series is designed with energy efficiency in mind. The ovens are designed to provide optimal heat distribution ensuring food cooks evenly while also conserving energy. This makes the models not only cost-effective in terms of energy bills but also environmentally friendly.

In summary, the Indesit K 642 VS/G and K 642 V/G models are practical, efficient, and stylish gas cookers ideal for any modern kitchen. With their user-friendly features, robust safety mechanisms, and versatile cooking options, they stand out as excellent choices for both novice cooks and culinary enthusiasts alike.