Indesit PI640 TC GB manual Installation, Positioning

Page 2

Installation

 

! Before operating your new appliance please read this

GB

instruction booklet carefully. It contains important

 

information for safe use, installation and care of the

 

 

appliance.

 

! Please keep these operating instructions for future

 

reference. Pass them on to possible new owners of the

 

appliance.

Positioning

!Keep packaging material out of the reach of children. It can become a choking or suffocation hazard (see Precautions and tips).

!The appliance must be installed by a qualified person according to the instructions provided. Incorrect installation may damage property or cause harm to people or animals.

!This unit may be installed and used only in permanently ventilated rooms according to the British Stancards Codes Of Practice: B.S. 6172 / B.S. 5440, Par. 2 and B.S. 6891 Current Editions. The following requirements must be observed:

The hob should not be installed in a bed sitting room with a volume of less than 20m3. If it is installed in a room of volume less than 5m3 an air vent of effective area of 110cm2 is required, if it is installed in a room of volume between 5m3 and

10m3 an air vent of effective airvent of 50cm2 is required, while if the volume exceeds 11m3 no airvent is required. However, if the room has a door or a window which opens directly to the outside no air vent is required even with the volume is between 5m3 and 11m3.

Intensive or prolonged use of the appliance could mean that extra aeration is needed, such as the opening of a window or a more powerful fan.

If there are other fuel burning appliances in the same room, B.S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements.

Fitting the appliance

The appliance can be installed next to furniture units which are no taller than the top of the cooker hob. The wall in direct contact with the back panel of the cooker must be made of non-flammable material. During operation the back panel of the cooker could reach a temperature of 50°C above room temperature. For proper installation of the cooker, the following precautions must be taken:

The hob may be located in a kitchen, a kitonen/diner or bed sitting room, but not in a bathroom or shower room.

The furniture standing next to the unit, that is higher than the working boards, must be placed at least 600 mm from the edge of the board.

The minimum distance combustible material can be fitted above the hob in line with the edges of the hob is 420mm. If is fitted below 420mm a space of 50mm must be allowed from the edges of the hob. The minimum distance combustible material kitchen units can be fitted directly above the hob is 700mm.

HOOD

HOOD

Min.420 mm.

Min. 600 mm.

min.650 mm. with hood

700min.mm. without hood

LESSTHAN 420

LESSTHAN 420

min.650 with hood

min.700 without hood

Min.420 mm.

 

 

 

 

min. 50

min. 50

 

 

The dimensions of the room for the furniture must be those indicated in the figures. Fixing hooks are provided which allow to place the hob plate on work tops that measure from 20 to 40 mm in thickness. To obtain a good fixing of the hob plate it is advisable to use all the hooks supplied.

 

 

 

555 mm

 

 

 

 

 

 

55

mm

 

 

mm

475

 

 

 

 

 

 

 

 

 

 

 

Fastening Clamps - Assembly Diagram

20

30

Clamp Position for

Clamp Position for

H=20mm top

H=30mm top

2

Image 2
Contents Operating Instructions HOBInstallation PositioningElectrical connection Gas Connection If the gas pressure is different than that prescribed, a Characteristic of the burners and nozzles Liquid Gas Natural GasDescription of the appliance Overall viewPractical Advise on Using the Burners Start-up and useDisposal Precautions and tipsGeneral safety Cleaning the appliance Maintenance and careSwitching the appliance off Greasing the TapsAssistance Xerox Business Services