JBL SAM2LF, SAM1HF manual Detailed Configurations and System Connection

Page 8

SAM1HF AND SAM2LF CONFIGURATION AND ASSEMBLY

IMPORTANT NOTE: Do not place the SAM1HF on its side. It must be mounted with the UHF DRIVER on the top, as shown below. Failure to do this will have a negative impact on the performance of this speaker.

Detailed Configurations and System Connection

Configuration 1: One SAM1HF and one SAM2LF vertical

Configuration 2: One SAM1HF and one SAM2LF horizontal

NOTE: Shown without the trim panel (baffle blocks) installed on the SAM1HF.

Image 8

Contents SAM1HF SAM2LF Contents Introduction Speaker Placement IncludedChannel Systems Floor Plan SAM1HF and SAM2LF Configuration and Assembly For Vertical MountingDetailed Configurations and System Connection SAM1HF and SAM2LF Configuration and Assembly Connecting the Speakers to the Rest of Your System Connections to the Synthesis ElectronicsSDEC-4000P Outputs to Amplifiers S4000IC Number SDEC-4000 With Bi-Amplified Speakers Active Crossover Connecting the Speaker to the Rest of Your System INPUT/OUTPUT Assignments with Passive CrossoverConnection to the Rest of the JBL Synthesis System SDEC-3000 With Passive Crossover SAM12xTroubleshooting PhaseSpecifications SAM1HF SAM2LF