Indesit 52 TCW Installation, Electrical connection, Positioning the Cooker, Moving the Cooker

Page 4

Installation

GB WARNING – THIS APPLIANCE MUST BE EARTHED.

Electrical connection

Electric cookers come without a power supply cable. The cooker is designed to operate on an electricity supply which conforms to the electrical data shown on the Rating Plate. The cooker can be connected to the mains only after removing the back panel of the cooker itself with a screwdriver. N.B.: the following installation procedure must be carried out by a qualified electrician. The electrical installation must comply with the IEE Regulations, Building & local By-Lays.

For the installation of the feeding cable carry out the following operations:

1 Open the terminal board by inserting a screwdriver into the side tabs of the cover. Use the screwdriver as a lever by pushing it down to open the cover (see diagram).

2Loosen the cable clamp screw and remove it, using a screwdriver as a lever (see figure).

3. Remove the wire contact screws L-N-, then fasten the wires under the screw heads, respecting the colour code: Black/Blue (N), Red/Brown (L) and Bare

Positioning the Cooker

mm

150 mm

650

 

150 mm

 

Moving the Cooker

The cooker is designed to fit between kitchen cabinets spaced 500mm apart. The space either side need only be sufficient to allow withdrawal of the cooker for servicing. It can be used with cabinets one side or both as well as in a corner setting. It can also be used free- standing.

Adjacent side walls which project above hob level, must not be nearer to the cooker than 150mm and should be protected by heat resistant material. Any overhanging surface or cooker hood should not be nearer than 650mm.

Before moving your cooker check that it is cool, and switch off at the cooker control unit.

Wire/Yellow-Green ().

zOnce the connections have been made, tighten all the terminal screws fully.

zFasten the supply cable in place with the clamp and close the cover of the terminal board.

The height of the cooker can be adjusted by means of adjustable feet in the plinth (900mm - 930mm). Adjust the feet by tilting the cooker from the side. Then install the product into position.

NOTE: This appliance must not be fitted on a platform.

Movement of your cooker is most easily achieved by lifting the front as follows:

Open the grill door sufficiently to allow a comfortable grip on the underside front edge of the oven roof, avoiding any grill elements.

Note: Take care in moving the cooker as it is heavy. Take care to ensure that any floor covering is not damaged.

Splashplate optional, apply to Parts Department (see Back Cover for contact number.)

4

Image 4
Contents Contents Operating InstructionsTechnical Characteristics IntroductionAlways For your SafetyNever Installation Electrical connectionPositioning the Cooker Moving the CookerFeatures Food SupportControl Panel Slow cooking ‘S’Hotplate Safety requirements for deep fat fryingUse of Hotplates Best Combinations Do NotChoosing Your Utensils Do not Grill GrillingTo operate the grill proceed as follows Fixing the Grill Pan HandleOven Using the Main Oven for Other FunctionsMain Oven Fan Cooking Points to consider when preparing food for Oven Cooking Chart- Meat Oven Cooking Chart- Baking Fan Oven CookingCare and Cleaning Remove the door inner glass as follows Stay Clean PanelRefit the door inner glass as follows Cooking Results Not Satisfactory? Disposal of your product Disposal of old electrical appliancesMonths Parts and Labour Guarantee Guarantee is subject to the following conditionsGuarantee does not cover Year Parts GuaranteeParts & Accessories Hotpoint ServiceUK 08448 24 24 Republic of Ireland 01 230