Indesit KD3G specifications Installation, Fig. a

Moving the Cooker

Installation

The appliance must only be installed by a

competent person. In the UK, CORGI registered installers undertake to work to safe and satisfactory standards.

Before moving your cooker check that it is cool, and switch off at the cooker control unit. Movement of your cooker is most easily achieved by lifting the front as follows:

Open the grill door sufficiently to allow a comfortable grip on the underside front edge of the oven roof, avoiding any grill elements.

￿Take care in moving the

cooker as it is heavy. Take care to ensure that any floor covering is not damaged. (see figure)

Splashplate optional, apply to Parts Department (see Back Cover for contact number.)

The following instructions should be read by a qualified technician to ensure that the appliance is installed, regulated and technically serviced correctly in compliance with current regulations.

￿remember to unplug the appliance from the mains before regulating the appliance or carrying out any maintenance work.

Positioning

￿this unit may be installed and used only in permanently ventilated rooms according to the British Standards Codes Of Practice: B.S. 6172/B.S. 5440, Par. 2 and B.S. 6891 Current Editions. The following requirements must be observed:

a. The cooker should not be installed in a bed sitting room with a volume of less than 20m3. If it is installed in a room of volume less than 5m3 an air vent of effective area of 110cm2 is required, if it is installed in a room of volume between 5m3 and 10m3 a supplementary airvent area of 50cm2 is required, if the volume exceeds 11m3 no airvent is required. However, if the room has a door or a window which opens directly to the outside no air vent is required even when the volume is between 5m3 and 11m3.

b. During prolonged use of the appliance you may consider it necessary to open a window to the outside to improve ventilation.

c. If there are other fuel burning appliances in the

same room, B.S.5440 Part 2 Current Edition, should, be consulted to determine the requisite air vent feet in the plinth (900mm - 915mm). Adjust the feet by tilting the cooker from the side. Then install the product into position.

￿This appliance must not be fitted on a platform.

The cooker is designed to fit between kitchen	GB
cabinets spaced 500mm apart. The space either
side need only be sufficient to allow withdrawal of
the cooker for servicing. It can be used with
cabinets one side or both as well as in a corner
setting. It can also be used free-standing.
Adjacent side walls which project above hob level,
must not be nearer to the cooker than 150mm or
65mm (Fig. A) and should be protected by heat
resistant material. Any overhanging surface or
cooker hood should not be nearer than 750mm.
(Fig.A)
a .The cooker may be located in a kitchen, a
diner or bed sitting room, but not in a bathroom or
shower room.
b .The hoods must be installed according to the
requirements in the hood handbook.
c .The wall in contact with the back of the cooker
must be of flameproof material.
d .The cooker is fitted with a safety chain that must
be attached to a hook, secured to the wall behind
the appliance.

￿some models can have their gas connection inverted. It is important to make sure the safety chain is always situated on the side which corresponds to the hose holder (Fig. B).

Tall cupboard on the right hand			Tall cupboard on the left hand
side of 50cm gas cooker			side of 50cm gas cooker
65 mm min	min			min	65 mm min
400 mm min	750 mm	150 mm min	65 mm min	750 mm	400 mm min

500 mm min 500 mm min

Fig. A

Fig. B

3