WM-90 PLASTER/MORTAR MIXER — START-UP PROCEDURE
4.Turn the engine switch (Figure 15) to the ON position.
| CAUTION | Preventing Drum Tipping |
|
|
|
Make certain the drum lock pin (Figures 18 and 19) is placed to the RIGHT (when viewing the mixer from the towpole end) of the drum stop block which is welded to the front side of the drum. Also make sure lock pin is fully engaged (locked). This will prevent the drum from tipping.
Figure 15. Engine ON/OFF Switch
5.The main start/stop switch located on the engine cover is (Figure 16) is used to start and stop the engine. Pull this switch outward to start the engine.
Figure 18. Drum Lock Pin (Side-View)
Figure 16. Start/Stop Switch (gasoline engine)
6.Place the belt slip lever (Figure 17) in the START/ STOP (disengaged) position.
Figure 19. Drum Lock Pin (Right Position)
7. Pull the starter grip (Figure 20) lightly until you feel resistance, then pull briskly. Return the starter grip gently.