Multiquip WM-90S manual WM-90 PLASTER/MORTAR Mixer Operation, OFF position

WM-90 PLASTER/MORTAR MIXER — OPERATION

Stopping the Mixer (Gasoline Engine)	Stopping the Mixer (Electric Motor)
1. Place the belt slip lever in the start/stop position	1. Place the electric motor's ON/OFF switch (Figure 7) in
(Figure 21).	the OFF position.

2.Push the main start/stop switch (Figure 16) inward to 2. Disconnect the electric motor's extension cord from its

stop the engine. power source.

3.Turn the fuel shut-off valve to the OFF position.

4.Disconnect the spark plug.

5.Clean mixer as referenced in the maintance section of this manual.

3.Clean mixer as referenced in the maintance section of this manual.

NOTE	It is recommended that the mixer's
	Start/Stop switch be used to stop
	the engine after every use.

Doing this will verify that the switch is working properly and presents no danger to the operator.

DANGER

DO NOT Disconnect the Start/Stop Switch

NEVER disable or disconnect the start/stop switch. It is provided for operator safety. Serious Injury may result if it is disabled, disconnected or improperly maintained.

WM-90 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (08/10/04) — PAGE 27