Installing the Casters
Follow the steps below to install the casters.
1.Empty the inside of the cabinet completely and lay
the KEGORATOR™ down on it’s side. We recommend that you place a piece of cardboard or cloth underneath the cabinet to prevent dents or scratches.
2.Insert the casters into the holes on the bottom corners of the cabinet. Tighten each caster by turning the nut clockwise with a wrench (not provided in the kit).
3.Once all four casters have been tightened, stand the cabinet in its upright position.
Note: Two of the casters include locking mechanisms to ensure the unit does not slide on hard floors. These two locking casters should be fastened at the front end of the unit, with the unlocked casters fasted on the rear end.
Installing the Beer Tap
Follow the steps below to install the beer tap. |
| Beer |
| ||
|
|
| Dispenser |
| |
1. Remove the cabinet plug located |
|
| Tower |
| |
|
|
|
| ||
on the work top. Firmly grasp the |
|
|
| 8.5" | |
cabinet plug, twist and pull upward. |
|
|
| ||
Beer Line |
|
|
| ||
Note: Keep this plug in a safe place |
|
|
|
| |
it will be required when using the |
|
|
|
| |
KEGORATOR™ as a refrigerator without |
| CO² Bottle |
| ||
a beer keg in use. |
|
|
| Shut Off Safely |
|
Keg |
|
|
|
| |
|
|
|
|
| |
2. There are notches on the | Coupler |
|
| 9" | |
|
|
|
|
| |
bottom of the draft arm |
|
|
|
|
|
assembly that line up with |
|
|
| CO² Line |
|
grooves inside the opening |
|
|
|
| |
in the top of the KEGORATOR™. |
|
|
|
| |
Align the draft arm with the |
|
|
| 15.5" | |
opening in the top of the unit, |
|
|
|
| |
|
|
| CO² Regulator |
| |
then place inside and twist until |
|
|
|
| |
|
|
| Low Pressure |
| |
secure. No screws are necessary, |
|
| Valve |
| |
it locks into place simply. The thin |
|
|
|
| |
black gasket is not mandatory for |
|
|
|
| |
assembly. |
| Beer Keg |
| CO² Tank | 15.5" |
Handle |
| (Not Included) | |||
|
|
|
|
| |
Beer
Dispenser
24.75"
23"
13.5"
23"
Tower
Installing the Guardrail
Follow these steps below to install the guardrail.
Beer Duct
Guard Rail
1.Place the guardrail on top of the cabinet.
2.Align all holes of the guardrail with the holes of the cabinet.
3.Secure the guardrail to the cabinet by placing inside corresponding rubber holes.
8