Operating Your KEGORATOR™
Dispensing Beer
Follow the steps below to dispense beer.
1.Make sure that the KEGORATOR™ is plugged in properly to a 120V, 60Hz, 15Amps grounded AC outlet.
2.Place the drip tray under the beer faucet to avoid messes from excess beer.
3.Open the beer faucet by pulling the tap towards you to dispense the beer.
NOTE: If for any reason the beer does not come out of the tap, please refer to theTapping the Beer Keg section.
4.Increase the pressure if the beer runs too slowly.
5.Hold the glass steady at a 45° angle. When it is 2/3 full, straighten the glass. Proper foam should be a tight creamy head and the collar on an average glass should be ¾” to 1” high, ideally.
NOTE: Only open the CO2 tank 1/4 turn to begin with and then use the regulator to adjust to desired pour. If it is not enough, continue to open the CO2 tank by 1/4 turn and use regulator until desired setting is reached.
NOTE: It is normal to see condensation form on the faucet. It is caused by the difference in
temperature between the cold beer and the inside of the faucet when beer is flowing through
the line.
Cleaning & Maintenance
Flushing the tubes
Follow the steps below to clean the keg tap and hoses. (see illustration below)
1.Turn off CO2 completely before attempting to clean.
2.Remove the hose from the coupler and carefully twist the dispenser faucet off
the top of the KEGORATOR™. | 1 Detach beer line |
|
3.Ensure that the dispenser handle is in the down position before flushing the hose.
If this is not set correctly, water cannot flow through. Hold the open end of the hose under running water for
4. In order to clean and remove any excess beer that
2 Flush hose with water
may leak into the unit space inside the door, remove the black rubber insulation and wipe with a wet towel
as needed.
Storage & Care
Follow the guidelines below to care for your KEGORATOR™ when not in use.
• Please adjust the temperature control dial to MID or LOW in colder
environments because this unit does not
unit. The temperature control dial is located on the back side of the KEGORATOR™ inside the cut out area at the bottom to the lower left.
•Always rinse the beer line if you do not intend to use your KEGORATOR™ for a period of time. First, turn off the CO2 and dispense beer until it stops. This will release pressure in the keg so that the coupler can safely be detached.
•To avoid permanent damage to the unit, never use sharp objects inside the KEGORATOR™.
10