Installation Instructions

Before using your wine cellar

•Remove the exterior and interior packing

•Check to be sure the following parts are included: o For VT-12TEDS-2Z, 4 Slide out shelves o 1 Instruction manual

o 1 Stainless steel handle o 2 Screws/fasteners

•Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

•Clean the interior surface with lukewarm water using a soft cloth.

INSTALLING YOUR WINE CELLAR

•Place your appliance on a floor that is strong enough to support the appliance when it is fully loaded. To level your appliance, adjust the front legs at the bottom of the appliance.

•Cellar must be placed as a freestanding unit—not to be built in.

•Installing the handle: The wine cooler comes with 1 stainless steel handle. To install:

1.Open door

2.Carefully remove seal from side of door where handle will be installed, starting at the upper corner

3.Insert included screws through holes from back of door frame

4.Screw on handle

5.Replace seal into door frame

•For proper installation, keep away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the coating and heat sources may increase electrical consumption. Extreme cold or hot ambient temperatures may cause the appliance not to perform properly.

•Not designed for placement in garage or basement. Designed for use inside the home.

1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1	9
i n f o @ v i n o t e m p . c o m