Vinotemp VT-26 owner manual Reversal Of Door Swing, To reverse, please do as follows

REVERSAL OF DOOR SWING

The door of the wine cellar could be opened either from the left or right side. The wine cellar is installed to open from the left side.

To reverse, please do as follows:

1.Disconnect the power, take out all the wine bottles and lay the wine cellar back on the ground.

2.Remove the upper hinge cover.

3.Unscrew the screws on the upper hinge board.

4.Remove the door and the upper hinge from the lower hinge axis.

5.Remove the upper hinge from the door. Install the upper hinge on the other side of the door.

6.Unscrew the two screws for the door handle. Remove the door handle and install it on the other side of the door.

7.Unscrew the two screws on the lower hinge. Remove the right lower hinge and left lower hinge and install them on the other side.

8.Remove the two upper hinge blocks to the other side.

9.Reinstall the door.

10.Install the upper hinge board and upper hinge cover.

Note: Please remember, do not power up the unit for 48 hours, to allow the coolants to settle inside the compressor.

Additional instructions for door handle installation:

1.Gently pull away the door gasket in the area where the handle is to be installed. The gasket is easily displaced by hand; no tools are necessary.

2.Use a Phillips head screwdriver to remove/install screws securing door handle. (Do not over tighten screws as this will cause damage to the handle.)

3.If needed, use a flat head screwdriver to remove the 2 decorative plugs from the front of the door or the plugs at the top of the door where the hinge is located, if they are located on the side you wish the handle to be installed on. Save the plugs for future use.

4.Replace the door gasket to its original position. Insert plugs into open door holes if desired.

1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1	11
i n f o @ v i n o t e m p . c o m