U-Line U-2175WCCS-00, U-2175WCCS-22, U-2175WCCOL-60 manual Removing and Installing Interior Shelves

Removing and Installing Interior Shelves

3

1

2

For models equipped with glass shelves having recessed shelf supports, remove the shelves as follows:

1.Pull shelf out about 6" (1), until back of shelf clears the “hump” on the right-hand side.

2.Tilt up right-hand edge of shelf (2).

3.Remove shelf from unit by pulling out (3).

Insert the shelves as follows:

1.To move to a different position in the unit, insert shelf at an angle, approximately 15-20°, over the rib in the side of the unit where you want to place the shelf. Place the shelf into the unit at an angle to clear the door.

2.Continue to slide the shelf into the unit at an angle until it clears the door.

Lower the shelf and push it in completely. Ensure the raised edge strip is toward the rear of the unit and the decorative graphics, if applied, are on the underside of the shelves.

IMPORTANT

• Make sure the shelves are inserted fully into the unit.

The edge strip toward the rear prevents cans and bottles from freezing against the cold evaporator.

For models equipped with glass shelves having shelf supports, remove the shelves as follows:

1.Open door completely.

2.Grasp the shelf edge in the center and slide the shelf from the unit.

Insert the shelves as follows:

Reposition the shelf as required, ensure the raised edge strip is toward the rear of the unit and graphics, if applied, are on the underside of the shelves.

Removing and Installing Door Shelves

1

2

For models equpped with door shelves:

To remove the door shelf:

1.Grasp shelf in center, and lift until the shelf notches (1) clear the pins (2).

2.Carefully pull the shelf away from the door.

To install the door shelf:

1.Holding the shelf in the center, center the shelf in the door at the desired location, slightly above the pins (2).

2.Lower the shelf onto the pins (2).

U-Line 2000 Series Maintenance 12