U-Line U-2175BEVCOL-60 manual Air Flow, Initial Startup, Electronic Control Panel, Digital Display

Page 6

3 Product Operation

Air Flow

IMPORTANT

The unit requires proper air flow to perform at its highest efficiency. Do not block the front grille or internal fans at any time, or the unit will not perform as expected. Do not install the unit behind a door.

Initial Startup

All U-Line controls are preset at the factory. Initial startup requires no adjustments.

IMPORTANT

U-Line recommends allowing the unit to run overnight before loading refrigerator or freezer with product.

To turn the unit on or off, press and hold POWER (1) for about ten seconds and release. The display will show the unit set-point temperature when turned on and display OFF when the unit is off.

Electronic Control Panel

Digital Display.

The electronic control with digital display shows a single continuous set-point temperature. The factory default set-point for Glass Door Refrigerators and Refrigerator models is 38°F. The factory default set-point for Wine Captain® models is 50°F. The set-point temperature is a gauge for further temperature adjustments.

Turning the Display Off. Wine Captain® Models and Glass Door Refrigerators have a DISPLAY OFF mode available through the control panel. This allows you to control if the display will be ON or OFF with the door closed. The icon sequence that follows will switch between both modes, On or Off:

1.Press and hold WARMER (2), and simultaneously within five seconds press POWER (1) three times.

2.The display will be either visible or dark with the door closed. To return to the previous mode, repeat Step 1.

Adjusting Air Temperature

IMPORTANT

Adjust the set point temperature in single increments, and wait 24 hours for the temperature to stabilize before rechecking.

1

2

3

4

5

To adjust the set point temperature:

1.Press and release either WARMER (2) or COOLER (4) to put the controller in the SET TEMPERATURE mode. The display

(3)will begin to flash the °F (or °C) symbol.

NOTE: This mode will self-cancel in five seconds, and the display (3) will show the original set-point temperature.

2.Within five seconds (while the °F (or °C) symbol is flashing), press WARMER or COOLER as required to adjust the set point temperature.

3.The change is committed five seconds after adjusting the temperature, and the display (3) will show the new set-point temperature.

Temperature °F °C Selection. U-Line products supplied for 110 VAC have temperatures displayed (3) default in Fahrenheit (°F). Models supplied for 220 VAC have temperatures displayed (3) default in Celsius (°C).

Easily adjust the display for either type temperature display.

Press and hold LIGHT (1) and simultaneously within five seconds press COOLER (5) three times to change the display

(3) as needed.

Temperature Display. The digital display shows set-point. Under normal operating conditions the temperatures will fluctuate based on a number of factors including door openings, product load, room temperature, and humidity. On passive cooled units the temperature will always be coolest toward the bottom.

To display actual temperature:

1.Press WARMER (2) for five seconds. The display (3) will indicate the actual temperature.

2.After about 10 seconds, the set point temperature will return to the display.

3

U-Line Product Operation

Page 5 Page 7
Image 6
Page 5 Page 7
Contents USE and Care Guide Read and save this Use and Care Guide Please Record Your Model InformationTable of Contents Safety Alert Definitions General PrecautionsWine Captain Model Features All 2000 Series Models FeatureWine Captain Model and Glass Door Refrigerator Features Glass Door Refrigerator FeaturesInitial Startup Adjusting Air TemperatureAir Flow Electronic Control PanelChecking Product Temperature To check the actual product temperature in the unitInterior Lighting Electronic Control Quick Guide TouchTop Storage Bin DrawersOther Models CrisperRed Wines Looking Behind the LabelWine Selections Suggestions White WinesIdeal Wine Storage Considerations Terminology DescriptionWine Rack Removal and Installation Wine Stocking RecommendationDo not remove the track rails from the cabinet Wood Trim Finishing Staining and final finish applicationInstalling the grille Light bulb ReplacementRemoving and Installing Grille LevelingRemoving and Installing Interior Shelves Removing and Installing Door ShelvesDoor Alignment and Adjustment To align and adjust the doorDoor Reversability Remove hole plugs Reinstall hinge to bottom oppositeReversing Black or White Doors Remove existing top hingeReversing Stainless Steel Glass Doors Pull Frame Away Push Glass Remove existing bottom hinge Exterior Cleaning Interior CleaningDefrosting Product Disposal Condensor CleaningStorage, Vacation and Moving Interval Every Six MonthsReplacement Parts Before Calling for ServiceIf Service is Required Troubleshooting GuideThis page intentionally left blank Line Use and Care Guide This page intentionally left blank Line Corporation Limited Warranty LINE.COM
Related manuals
Manual 23 pages 56.58 Kb

U-2115RB-00, U-2175BEVCS-02, U-2115WCS-00, U-2115WCOL-00, U-2175BEVCOL-00 specifications

U-Line U-2175 series of products exemplifies cutting-edge design and technology in the realm of under-counter refrigeration. This series includes models such as U-2175WCCS-00, U-2175WCCS-22, U-2175WCCOL-60, U-2175WCCOL-02, and U-2175BEVCS-00, each offering unique features tailored to enhance your home or commercial space.

The U-2175WCCS-00 and U-2175WCCS-22 are undercounter wine and beverage centers, boasting a sleek and modern aesthetic. They feature U-Line's exclusive convection cooling system, which ensures that beverages are cooled evenly and efficiently across the unit. These models come with adjustable shelves that accommodate a variety of bottle sizes, from standard wine bottles to larger formats, allowing for flexibility in storage. The glass doors of these models provide visibility while protecting the contents from UV light, preserving the quality of your beverages. Additionally, the LED lighting illuminates the interior, not only enhancing visibility but also creating an inviting ambiance.

The U-2175WCCOL-60 and U-2175WCCOL-02 models are designed with a focus on versatility and capacity. These units feature solid doors and a high-profile design, making them an elegant addition to any decor. The customizable, integrated design allows for a seamless installation within existing cabinetry, perfect for modern kitchens and bars. These models are equipped with U-Line’s advanced temperature control technology, enabling precise temperature management for different types of wine or beverages, ensuring they are served at the optimal temperature.

For those interested in a dedicated beverage cooler, the U-2175BEVCS-00 excels in this area. This model is specifically designed to store a wide variety of canned and bottled beverages, with spacious shelves that can be adjusted to fit drinks of varying sizes. The unit’s powerful cooling system works quietly and efficiently, allowing users to enjoy chilled refreshments without disrupting their environment. Moreover, with features like door locks and security settings, this model guarantees the safety of your prized collection.

In conclusion, the U-Line U-2175 series represents a blend of functionality, style, and advanced technology. Whether for wine enthusiasts or casual entertainers, these models provide the perfect solution for beverage storage and display, making them an invaluable addition to any home or business. Their innovative designs prioritize both aesthetics and practicality, ensuring your beverages are stored optimally while enhancing your space’s overall appeal.
Top Page Image Contents