U-Line CO29FF manual Leveling, Ice Cube Thickness Adjustment Interval As Required

Page 11

Ice Cube Thickness Adjustment

Interval - As Required

On ice maker equipped models, the cube size may be adjusted by changing the amount of water injected into the ice maker assembly as follows:

ULIN_0273_A

Figure 11

1. Remove the ice maker assembly cover (Figure 11).

ULIN_0056_A

Figure 12

2.Locate the adjusting screw on the ice maker assembly control box. The adjusting screw is just below the minus (-) and plus (+) signs on the control box (Figure 12).

NOTE: Make adjustments in small increments. Too large of an adjustment could cause the unit to malfunction.

CAUTION

Too large of an adjustment to the screw can cause the water to overflow the ice maker and can cause property damage.

3.Turn the adjusting screw toward the minus (-) sign (clockwise) for smaller cubes or toward the plus (+) sign (counterclockwise) for larger cubes.

4. Install the ice maker assembly cover.

IMPORTANT

Use only genuine U-Line replacement parts. U-Line ice maker parts are not the same as standard FSP Whirlpool parts. Using non U-Line parts can reduce ice rate, cause water to overflow from ice maker mold, damage the unit, and may void the warranty.

Leveling

It is important that this unit is set level, for proper door and ice maker operation.

ULIN_0211_A

Figure 13

Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown (Figure 13).

NOTE: This model DOES NOT have leveling feet. This model MUST be placed on a level surface to operate properly.

CO29FF

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Use and Care Guide Introduction Warranty RegistrationPlease Record Your Model Information Table of Contents This page intentionally left blank Safety Precautions Safety Alert DefinitionsGeneral Precautions Operation Product FeaturesOrigins Ice Maker/Refrigerator Model CO29FF Initial StartupIce Maker Temperature ControlChecking Product Temperature Adjusting TemperatureStorage, Vacation, Moving Normal Operating SoundsOutdoor, Marine and RV Usage Product Disposal General CleaningMaintenance Cleaning and MaintenanceInlet Screen Interval Every Twelve Months Condenser CleaningIce Maker Maintenance Interval Every Three MonthsLeveling Ice Cube Thickness Adjustment Interval As RequiredDoor Reversal Door Alignment Check and AdjustmentInvert Service Before Calling for ServiceIf Service is Required Replacement PartsTroubleshooting What to check when problems occur Troubleshooting GuideThis page intentionally left blank CO29FF CO29FF Line Corporation Limited Warranty For General Inquiries For Service and Parts Assistance
Top Page Image Contents