U-Line SS-98, B198, ADA151M, B12115, WH95, B195 manual BI95 & BI98, Door Reversal, Reversing the Door

7 Door Reversal

BI95 & BI98

Reversing the Door

All units may be left- or right-hand opening.

Note: The grille should not yet be installed. If it has been installed, remove it for door reversing.

To reverse the door:

1.Remove top hinge from cabinet (three screws). See Figure 1. Hold door to keep it from falling.

2.Lift the door off the bottom hinge.

1 2

3.Remove bottom hinge from cabinet (two screws). See Figure 2. Remove screws on opposite side of cabinet (Figure 3). Note that there may be a nut behind one or both screws on either side.

3 4

4.Install hinge on opposite side, bottom of cabinet. See Figure 4. Replace nut on

back side where installed. Align hinge outer edge with cabinet before tightening screws.

5. Relocate plastic spacer/
bushing on bottom of door
to opposite side, and place
door on bottom hinge pin.
See Figure 5. Clean out	5
bushing hole in door bottom
with a screwdriver if necessary.

6.Remove plastic hole plug from door handle and relocate on opposite side. See Figure 6.

	Hinge
Plastic			Plastic
Plug Hole			Plug Hole
	Screw
Right Side			Left Side
Door Swing			Door Swing
Right Side	Invert	Invert	6
Hinge	Screw	Hinge

7.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge. See Figure 7.

8.Remove three plastic screw

plugs from hinge holes, top of cabinet, opposite side. Be careful not to scratch

cabinet. See Figure 8.

9. Place door on lower hinge pin. Invert and install upper

hinge on door.

10. Fasten upper hinge to unit (three screws). Partially

tighten screws. See Figure7 9.

11.Adjust door to assure proper seal. Tighten upper and lower

hinge screws securely.

12. Replace three plastic plugs removed in Step 8 into holes on top of unit. Replace screws in holes in bottom of unit on opposite side.

8

U-Line Door Reversal 9