OPERATING INSTRUCTIONS
Power On/Off
Use the rear panel slide switch to turn the Sound Bar ON and OFF. The LEDs on the front panel light or blink depending on the Sound Bar status.
Battery Charging
To charge the Sound Bar battery, connect the mini USB connector to the rear panel DC 5 V connector. Connect the USB connector to a USB port on a computer. Allow the unit to charge fully before using it. The yellow LED is off when fully charged.
Volume Adjustment
Rotate the rear panel volume control to increase or decrease the volume. Also a Bluetooth® device can also be used to increase or decrease the volume when the device and the Sound Bar are paired. It is recommended leaving this control at maximum volume and controlling the volume with the connected device.
AUX-IN Cable for Audio
The Sound Bar has an auxiliary audio input which can accept audio signals from various devices. The
Bluetooth® Pairing
NOTE: The following procedure is generic. Procedures for pairing Bluetooth® devices may vary slightly manufacturer to manufacturer.
1.Turn the the Sound Bar ON. The blue front panel LED will blink rapidly.
2.Select the Bluetooth® setup option on the Bluetooth® device to be paired (please refer to the instruction manual to enter Bluetooth® setup, turn Bluetooth® on/off, and perform pairing). Access the Bluetooth® function and set the Bluetooth® function to ON.
3.A prompt to pair should appear on your Bluetooth® device. Accept the request and initiate the pairing process. A prompt to enter a PIN number or passkey may appear. The default passkey for the Sound Bar is “0000”.
4.At this point a prompt stating pairing complete should appear on your Bluetooth® device.
5.The front panel blue LED will be ON.
6.Once the Sound Bar is paired with the Bluetooth® device
6