TROUBLE-SHOOTING GUIDE
1.The appliance does not work.
•Is there a power failure?
•Is the plug properly inserted in the socket?
•Is the main switch switched on?
•Has the fuse blown?
•Is the thermostat set to • position?
2.The temperature inside the compartments is not cold enough.
•Do the doors close properly?
•Is the appliance installed near a heat source?
•Is the thermostat correctly set?
•Is air circulation inhibited?
3.The temperature inside the refrigerator compartment is too cold.
•Is the thermostat correctly set?
4.Water collects in the bottom of the refrigerator compartment.
•Is the defrost water
5.The internal light does not work. First refer to point 1, and then:
•Unplug the appliance from the mains power supply.
•Refer to the instructions and illustration on the enclosed sheet to access the
•Check the bulb and replace if necessary. (E14 type, 15W max).
6.Excessive formation of frost/ice in the low temperature compartment.
•Is the low temperature compartment door properly closed?
Note:
•Gurgling or hissing noises inside the refrigerating circuit are quite normal.
AFTER-SALE SERVICE
Before contacting our
1.Try to remedy the problem (see “Trouble- shooting guide”).
2.Restart the appliance to see if the fault repeats. If the fault persists, switch off the appliance and switch on again after an hour.
3.If the fault still persists, contact the After- Sale Service and specify the following:
•the nature of the problem
•the model
•the service number (the number after SERVICE on the rating plate located on the side of the fruit and vegetable drawer)
•your full address
•your telephone number plus area code.
S E R V I C E 0000 000 00000
Note: changes to the door opening direction carried out by our Customer Service are not covered in the terms of the guarantee.
INSTALLATION
•Do not install the appliance near a heat source (minimum distances: 30 cm from solid fuel or gasoil stoves, 3 cm from electric ovens and hobs).
•Install the appliance in a dry and well- ventilated place.
•Do not cover the air vents.
•Clean the appliance interior (see relevant chapters).
•Mount the accessories.
ELECTRICAL CONNECTION
•Electrical connections must be made in accordance with local regulations.
•Voltage and absorption rates are indicated on the rating plate.
•The appliance must be earthed as prescribed by law. The manufacturer declines all liability for personal injury or damage to property or animals resulting from failure to comply with the above requirements.
•If the appliance plug and wall socket are incompatible, the socket must be replaced by a qualified electrician.
•Do not use extension leads or multiple adapters.
ELECTRICAL DISCONNECTION
•It must be possible to disconnect the appliance from the mains by removing the plug or by disconnecting a
13