Description of the hood Fig | Smeg KSIV960X1 guide

Description of the hood - Fig. 1

1 Control panel

2 Grease filter

3 Grease filter release handle

4 Halogen lamp

5 Vapour screen

6 Telescopic chimney

7 Air outlet (used for filter version only)

Operation –

Model with electronic controls

1	2	3 4	5	6 7	8		9
1- Motor OFF button
2-	ON button and motor speed selection				button	1 - 2	- 3 -
3-	1 - 2	- . . . .
3-	Speed 1 LED
4-	Speed 2 LED and metal grease filter				saturation LED (in
	this latter case, the LED will flash - See instructions on
	grease filter cleaning).
	Once	the grease	filters	have been cleaned,		press	button

1for about 3 seconds until you hear the acoustic signal (beep): the LED 4 will now stop flashing.

5- Speed 3 LED and active carbon filter saturation LED (in this latter case, the LED will flash - See instructions on active carbon filter replacement).

Once you have replaced the charcoal filter, press button

1for about 3 seconds until you hear the acoustic signal (beep). LED 5 will now stop flashing.

Warning!

The active carbon filter saturation LED is not activated. In order to activate the active carbon filter saturation indicator, press buttons 2 and 7 simultaneously for 3

		seconds. Initially,			only LED 4 will flash, then	after the
		3 seconds		have passed, LED 5 will also start		flashing,
		indicating that the active carbon filter saturation control
		system is		active.
		To switch off the system, re-press the same two
		buttons: after 3 seconds LED 5 will stop flashing and
6		the device will be switched off.
6	-	Intensive		speed	LED
7	-	Intensive		speed	ON switch
		This speed should be used when the concentration of
		cooking fumes or odours is particularly strong (for
		example when frying, cooking fish etc.).				T h e
		fast	speed	will run for about 5 minutes and then return
		to the speed previously set automatically (1,				2 or 3),
		or switch off if no speed was selected.
		To turn off the fast speed, before the end of the 5 minutes,
8		press button 1 or button 2.
8	-	OFF	lamp	button
9	-	ON	lamp	button

If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. by pulling out the plug. Then plug it in again and try once more before contacting the Technical Assistance Service.

1 3