This, Operation All cooker hood versions

Functioning-Modelwithdisplay

A – OFF key (Display off) /Stand-by (led lit on the display)

–press for a long time to select the function desired. B - Lighting, on/off.

C - Timer for selected speed (visualizes the speed selected and flashing LED on the lower side of the display). This knob permits the operation of the cooker hood for a established period:

20 minutes if the speed selected is 1

15 minutes if the speed selected is 2

10 minutes if the speed selected is 3

5 minutes if the intensive speed P is selected.

D - Display showing:

•Fan speed (1-3-P).

•Change grease filters (grease filter saturation indicator - F)

After washing the anti-grease filter, depress knob

Afor about 3 seconds. The letter F will disappear from the display.

•Change activated carbon filters (carbon filter saturation indicator - C).

After replacing the charcoal filter, depress knob

Afor about 3 seconds. The letter C will disappear from the display.

•When the led in the lower right side is on, it indicates that the cooker hood is ready for operation (“standby” position), the flashing LED indicates that the timer has been activated for selected speed.

Attention! The active carbon filter saturation indicator is normally deactivated, to activate it:

Set the hood on OFF (display off), press keys C and G contemporaneously for 3 secs.

		Initially,		only letter	F will fbe displayed, then after the
		3 seconds have passed, letter C will be displayed as
		well, indicating that the carbon filter saturation control
		system		is active.
		To switch off the system, re-press the same two
		buttons: letter C appear on display and after 3 seconds
E		letter	it	disappear	and the device will be switched off.
E	-	Knob	to	decrease	the	speed.
F	-	Knob	to	increase	the	speed.
G -		Timed intensive speed				button: the hood operates at this
		speed for 5 minutes and than returns to the previus
		settings. The display will show P and a blinking dot.
		This	function can		be cancelled by pressing button A.

If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. by pulling out the plug. Then plug it in again and try once more before contacting the Technical Assistance Service.

Warning!

Always press the fan off button A before disconnecting the hood from the mains supply.

Operation –

All cooker hood versions

Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.

1 4

system

speed.

This

Operation –

All cooker hood versions