SERVICING
Always disconnect the appliance from the electricity main before proceeding with any servicing operation.
7)REPLACING THE ELECTRICAL COMPONENTS
For access to the various parts, remove the hotplate from the top of the cabinet. Then overturn it, unscrew screw and remove under part.
After these actions is possible to work on the plates, commutators, clamps and input cable.
N.B. In case of substitution of the input cable, the installer must keep the “earth” conductor longer than “live” ones, and must respect the cautions in paragraph “Electrical connection”.
To reassemble the appliance repeat the inverse process.
8)TECHNICAL CHARACTERISTICS OF THE ELECTRICAL COMPONENTS
To facilitate the job of the installer we present a scheme with the characteristics of the components.
POWER OF ELECTRICAL COMPONENTS DENOMINATIONS W
Denominations |
|
| W | |
|
|
|
|
|
Normal plate Ø 145 mm – 7 positions with the protector |
|
|
|
|
| 1000 |
| ||
|
|
|
|
|
Normal plate Ø 180 mm – 7 positions with the protector |
| 1500 |
| |
|
|
|
|
|
Rapid plate Ø 145 mm – 7 positions |
| 1500 |
| |
|
|
|
|
|
Rapid plate Ø 180 mm – 7 positions |
| 2000 |
| |
|
|
|
|
|
TYPE AND SECTION OF THE POWER CABLES
Cable type
Single phase power
230 - 240 V~
Rubber H05
3 X 1.5 mm2 (*)
Polycroropene H05
3 X 1.5 mm2 (*)
(*) keeping in mind the contemporaneousness factor
8