Smeg KR37X Activating the alarm signal, Changing The Activated Charcoal Filter, Light Replacement

Activated Charcoal Filter (Recirculation Version)

•This cannot be washed or regenerated, and must be changed when all the command LEDs start to flash, or at least once every 4 months.

Activating the alarm signal

•In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or at a later date.

•Press and hold the Delay button (T4) on the keypad for 5 seconds and the following will be dis- played:

•Leds (L1-L2-L3) flash twice – Activated Charcoal Filter saturation alarm ACTIVATED.

•Leds (L1-L2-L3) flash once – Activated Charcoal Filter saturation alarm DEACTI-

VATED.

CHANGING THE ACTIVATED CHARCOAL FILTER

Resetting the alarm signal

• Press any of the buttons except the Light button.

Changing the Filter

•Open the lighting unit by pulling on the nocth.

•Remove the Metal grease filters.

•Remove the saturated Activated Charcoal filter, as shown in the figure.

•Fit the new Filter, hooking it into place.

•Replace the Metal grease filters.

•Replace the lighting unit.

Lighting

LIGHT REPLACEMENT

20 W halogen light.

• Extract the lamp from the lamp holder by pulling gently.

• Replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes.

EN	2
	21