Smeg STX4-3 instruction manual Washing programs, Removing the Dishes

User instructions

Programming procedure:

•Press the PROGRAM SELECTION (2) and DELAYED START (3) buttons simultaneously for 3 seconds until the DISPLAY (6) shows the symbol of the parameter to be modified (see table);

•Press the DELAYED START button (3) to modify the parameter;

•Press the PROGRAM SELECTION button (2) to change the parameter for modification and/or to exit from the procedure.

DISPLAY SYMBOL	PARAMETER	ADJUSTABLE VALUE	EFFECT
	ACOUSTIC DEVICE	0	OFF
		1	ON
	WATER PRESSURE	0	NORMAL
		1	LOW

3.3Washing programs

The dishwasher is equipped with a control panel and an INFORMATION DISPLAY, described in chapter "3. Description of the controls", from which it is possible to carry out all the power switch- on, switch-off and programming operations.

See enclosed program table for washing cycles and the procedure for starting the dishwasher and switching it on/off.

Before starting a washing program make sure that:

•The water supply tap is open.

•The correct amount of detergent has been added to the dispenser.

•The baskets have been correctly loaded.

•The spray arms are able to rotate freely and without obstruction.

•The dishwasher door is securely closed.

TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT

•Always try to run the dishwasher fully loaded.

•Do not wash the dishes in running water.

•Use the washing program that is most appropriate for each type of load.

•Do not carry out any preliminary rinsing.

•If available, connect the dishwasher to a hot water supply up to 60°C.

•When possible, disable the drying cycle and leave the door open at the end of the washing cycle: the residual air and heat will dry the dishes perfectly.

TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT The phosphates contained in dishwasher detergents are harmful to the environment. To avoid using excessive amounts of detergent and to save on electricity, observe the following:

•separate the more delicate items from dishes that are more resistant to aggressive detergents and high temperatures;

•do not pour the detergent directly on the dishes.

REMOVING THE DISHES

At the end of the washing program, wait at least 20 minutes before removing the dishes, to allow them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in the lower basket, it is advisable to unload the lower basket first, and then the upper basket.

29