Smeg DI912 instruction manual Installation instructions, Installation and hook-up

Page 6

Installation instructions

2. Installation and hook-up

Remove the polystyrene basket retainers.

Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under continuous worktops, and screw them to the adjacent units. To facilitate the installation procedure, the intake and drain hoses can be positioned in any direction; make sure that the hoses are not kinked, crushed or pulled too tightly. Make sure to tighten the locking ring-nut once the pipes have been placed in the direction required. A hole at least 8 cm in diameter is required to allow the power supply cable and pipes to pass.

Level the appliance on the floor using its adjustable feet. This operation is essential for the ensuring correct operation of the dishwasher.

Building-in a dishwasher underneath a ceramic hob is absolutely forbidden.

A dishwasher can be built-in underneath a conventional hob provided there is no break in the kitchen worktop, and the dishwasher and hob are installed and secured correctly, so that no hazards are generated.

WARNING!

Some protective systems preventing access to the door opening and closing mechanisms are not active until the appliance has been installed.

If the appliance is not built into a cabinet, or is built into a cabinet but without one or both front panels, some mechanical parts which may cause serious injury when the door is opened and closed are accessible.

In all cases, never insert your hands into openings at the side of the bottom panel while the door is being opened or closed.

Never open the door of the appliance with the bottom drawer partially or completely open - If the bottom of the cabinet in which the appliance is built-in contains a drawer, make sure that it is completely closed before opening the dishwasher door. Opening the door with the bottom drawer partially or completely open may damage the bottom panel fixing devices.

41

Image 6
Contents Dishwasher Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation instructions Installation and hook-upElectrical connection and precautions Water supply connectionDrain Connection When Cleaning and Maintaining the Appliance If the Appliance is Provided with a Plugless Supply CordFuse replacement For UK onlyDescription of the controls Upper panelOption Light Program Delay ButtonOption Button WASH-ZONE ButtonSetting the Washing Program and Switching on DirtWash at 45C Cold rinse Cancelling the Current Program Washing programsTable for Certification Bodies Changing the Program Extra ProgramsTo Save on ENERGY! … and Protect the Environment Adjusting the Water Softening System Water Hardness TableEND of Cycle Removing the DishesUsing the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent General warnings and recommendations 1 ProductsUser instructions Using the baskets User instructions Cutlery Basket Cleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Cleaning the Filter Unit General Warnings and Recommendations for Correct Maintenance If the dishes are not being cleaned properly, check that Troubleshooting Fault DescriptionWater intake system malfunction Technical Data Page Min ,2 max ,2 kg