Placing and Installation
Choosing the Right Place
Place the appliance in a dry and regularly ventilated room. Allowed ambient temperature depends on the model (class) of the appliance and is stated on the rating plate of the appliance. This refrigerator is class N.
Class | Ambient Temperature |
SN | from + 56°F to + 90°F |
N (normal) | from + 62°F to + 90°F |
ST | from + 64°F to +100°F |
T (tropical) | from + 64°F to +120°F |
The appliance may be exposed to lower or higher temperatures but only for a short period of time and the temperature should never be lower than 41°F. Never place the appliance near heat emitting devices (e.g. cooker, radiator, water heater or similar devices) and do not expose it to direct sunlight.
Connection to Power Supply
Connect this appliance to a 3 prong power supply socket outlet (which has a ground terminal). If you only have a two prong outlet have it replaced by a qualified technician with an outlet that meets the local codes.
“DO NOT USE AN EXTENSION CORD.”
Required nominal voltage and frequency are indicated on the rating plate.
The connection to the power supply and grounding has to be made according to current standards and regulations. The appliance resists temporary voltage tolerance from
Removal/Replacing of the Drawers
To remove the drawers from the refrigerator these directions need to be followed:
•Pull the drawer out towards you completely.
•On both sides of the drawer there are hinges.
•On each hinge there is a black lever.
•The left lever should be pulled up.
•The right lever should be pulled down.
•Both levers should be pulled at the same time while continuing to pull out the drawer.
To reinstall the drawers on the appliance:
•Just simply line up the hinges on the drawer and the hinges on the appliance and gently push the drawer in.
•Once lined up close the drawer completely then open again to make sure the drawer is on track.
Instructions for Use
4