Summit SPR7OS owner manual BI540 BI541 CT67BI ALB651-ALB653B CT66BI-CT66B Series

Page 12

Page 12

APPLIANCE OPERATION

Felix Storch, Inc.

SUMMIT PROFESSIONAL DIV.

FF6BI - FF7BI – SCR600LOS – SPR7OS- SPR601OS – SCR600BI - SWC6GBI - ALB751— ALB753B Series

DEFROST SYSTEM, OPERATION AND SHELF ADJUSTMENT - All models of the above series are all-refrigerators, with no freezer compartment and an auto-defrost system. During the compressor operation, ice will build along the rear cold wall (the evaporator plate is behind the wall). During the compressor’s off-cycle, ice will melt, drip down, collect in the trough at the bottom and drain through the small hole into a tray above the compressor; where the compressor’s heat will evaporate the water. If you notice excessive ice build-up on the rear wall, try setting the thermostat to a slightly warmer setting; be sure that the gasket is sealing well – that there is no obstruction of the drain hole in the bottom rear of these units. Models with black cabinets include glass shelves. These shelves stop short an inch before the back wall, which is essential for air flow and the automatic defrost system. Do not block with food or containers. All models have removable easily adjustable shelves. To remove a shelf, simply lift the rear of the shelf out of its locking position and slide the shelves forward. Replace shelves the same way, being sure they lock into place. The thermostat of these units is located on the right hand side top, as you face the refrigerator. Turn clockwise for colder operation, and counter clockwise to save energy and increase the temperature. The light on the FF6BI models is controlled by an automatic plunger switch whenever the door is opened. Models with glass doors and flat door liners have a rocker switch to manually turn the light on or off. The light should be kept off when the door is closed to save energy and help keep interior temperatures lower.

BI540 – BI541 – CT67BI - ALB651—ALB653B - CT66BI—CT66B Series

DEFROST SYSTEM, OPERATION AND SHELF ADJUSTMENT - Models above are refrigerator-freezer combinations with a manual defrost freezer section and an automatic defrost fresh-food section. When ice builds to ½ inch around the freezer; empty the contents of the whole unit and defrost carefully (DO NOT USE SHARP OBJECTS) following directions earlier in this manual. The fresh food section will defrost itself, exactly like the models in the previous section. The freezer in this unit is rated four stars, which makes it suitable for ice-cream and short term storage of meats and other perishable items. For best storage, be sure not to over-pack and assure the freezer door closes fully. Shelves adjust the same as the section above. Models with black cabinets as well as CT67BI models include glass shelves. These shelves stop short an inch before the back wall, which is essential for air flow and the automatic defrost system. Do not block with food or containers. The thermostat of these units is located on the right hand side, top, as you face the refrigerator. Turn clockwise for colder operation, and counter clockwise to save energy and increase the temperature. Lights on these units are all controlled by an automatic plunger type switch.

SCFF55 Series

These units are frost-free freezers with a fan cooled interior. The cooling is provided by the evaporator module mounted to the top of the unit. Air is circulated through the fan grill at the front of the unit and an outlet at the rear of the unit. Try to keep the air path as free as possible for optimal performance. No defrosting of these units is normally needed. There are no user serviceable parts within the evaporator module, so do not tamper or attempt to move this part. It is part of the sealed refrigeration system. Models with black cabinets include glass shelves. These shelves stop short an inch before the back wall, which is essential for air flow. Do not block with food or containers All models have removable easily adjustable shelves. To remove a shelf, simply lift the rear of the shelf out of its locking position and slide the shelves forward. Replace shelves the same way, being sure they lock into place. The light in the SCFF55 models is controlled by a manual rocker switch. Keep the light off when the door is closed for better performance and to save energy. Models with ice-makers installed do not include an interior light.

SWC6GBI Series Wine Cellars

These wine cellars are fully automatic defrost (see description of the defrost system under Model FF6BI series). There is a light in the upper right corner, controlled by a rocker switch. Base models of the SWC6G series have chrome plated shelves, while some models are equipped with optional flat wire shelves or wooden shelves. For maximum capacity, it is possible to lay wine bottles at the rear of the shelves cross-wise, behind the bottles facing forward. Keep one inch of clearance behind the shelves and the rear wall for air circulation and the defrost system. Glass doors should be cleaned with non-abrasive glass cleaners, and it is recommended that the interiors be cleaned with only a baking soda –water- mix so odors are not left behind that can be absorbed by corks. These models are one temperature zone only, although the lower shelves are normally a few degrees colder than the upper shelves.

Image 12
Contents USE and Care Guide Appliance Safety Installation Instructions UnpackingChoosing the Right Place Appliance USE Reversing the Door Swing Selected modelsAppliance Operation Base Grill some models onlyCleaning Your Frost-Free Refrigerator Appliance CareTemperature Selection Mechanical Thermostat InstructionsKeypad Lock optional on most models Alarm Instructions alarms are optional on most models Summit Professional DIV BI540 BI541 CT67BI ALB651-ALB653B CT66BI-CT66B Series BI605FF Series Before Calling for SERVICE… Installing a Panel Into a Summit Frame FR SuffixTroubleshooting Your refrigerator or freezer will not operateWarranty

SPR7OS specifications

The Summit SPR7OS is an advanced outdoor rugged tablet designed specifically for professionals who require a reliable and durable device in challenging environments. Featuring an impressive blend of robust construction, cutting-edge technology, and user-friendly functionality, the SPR7OS has become a go-to solution for various industries, including construction, field service, logistics, and emergency services.

One of the standout characteristics of the SPR7OS is its ruggedness. Built to withstand harsh conditions, the device meets IP68 standards for water and dust resistance, ensuring that it can operate effectively even in extreme weather. Additionally, it is certified to military standards (MIL-STD-810G), meaning it can endure drops, shocks, and vibrations, making it suitable for demanding field applications.

The SPR7OS sports a 7-inch sunlight-readable display that offers high-definition resolution. This feature ensures that users can view vital information clearly, even in bright outdoor conditions. The touchscreen is glove-compatible, allowing for seamless interaction without the need to remove protective gear, which is crucial for field personnel.

Powered by a robust processor and ample RAM, the SPR7OS delivers fast performance and efficient multitasking capabilities. This means users can run various applications simultaneously without lag, enhancing productivity during critical tasks. The operating system is built on a versatile platform, typically running Windows or Android, providing flexibility in app support and integration with existing systems in various industries.

Connectivity is another significant advantage of the Summit SPR7OS. It supports 4G LTE cellular connectivity, Wi-Fi, and Bluetooth, allowing field workers to stay connected and access real-time data wherever they are. The inclusion of GPS functionality also aids in navigation and tracking, essential for logistics and emergency response applications.

Battery life is a key consideration for any outdoor device, and the SPR7OS does not disappoint. It features a high-capacity battery designed to last through long work shifts, ensuring that users can rely on the tablet throughout the day without the need for frequent recharging.

In summary, the Summit SPR7OS is a powerful tool engineered for resilience and efficiency in demanding settings. Its combination of ruggedness, advanced technology, and practical features makes it an essential device for professionals across various sectors. With its capacity to endure tough conditions while providing seamless functionality, the SPR7OS stands out in the market of rugged tablets, making it a trusted partner in the field.