Turbo Air Temperature Control Settings and Warranty Guide

Page 5

BASICOPERATION

1.Plug in and turn on the power and lamp switch located on the top of the bottom grille right side.

The Display panel will be lighted and make a beep sound. The compressor will begin to run. After turning on the power, the fluorescent lamp will come on in a few minutes.

2.The default temperature setting is No. “-8˚F” for the TGF-23F.

The default temperature setting is No. “-8˚F” for the TGF-49F.

The default temperature setting is No. “-8˚F” for the TGF-72F.

3.The compressor is automatically cycled by the electronic controller (PCB, F-Sensor).

4.The Defrost cycle is automatically controlled by the D-sensor, and the PCB.

5.Push the temperature up button for higher temperatures and the temperature down button for lower temperatures.

6.Evaporator fan motor will run after all doors are completely closed.

7.Good Air Flow in freezer is critical.

Be careful to load product so that it neither presses against the back wall, nor reaches within four inches from the evaporator compartment.

5

Turbo air

Image 5
Contents Freezer Contents Installation Cleaning Basic Operation Display Panel of Freezer TGF- 23F Interior Temp Indicator Lamp SwitchTemp Control Button Turbo Freeze Door Opening FAN Running Turbo Freeze ButtonTurbo Freeze Door Opening FAN Running Display Panel of Freezer TGF 49F, TGF 72FDefrost UP/DOWN Button Temperature control buttonTurbo Freeze Door Opening Indicator Inner Temperature DisplayFAN Running Indicator Symptoms Causes Solutions Before Requesting ServiceManufacturing Company ONE Year WarrantyWhat is not Covered by this Warranty Warranty Claims
Related manuals
Manual 128 pages 61.87 Kb