AEG 290-6I installation instructions Installation Location

Page 7

¥Remove pins (A) and (B).

¥Remove all adhesive tape and packing pieces from the interior of the appliance.

Installation

A

C

D

B

Installation Location

The appliance should be set up in a well ventilated, dry room.

Energy use is affected by the ambient temperature. The appliance should therefore

Ðnot be exposed to direct sunlight;

Ðnot be installed next to radiators, cookers or other sources of heat;

Ðonly be installed at a location whose ambient temperature corre- sponds to the climate classification, for which the appliance is desi- gned.

The climate classification can be found on the serial plate, which is located at the left on the inside of the appliance.

The following table shows which ambient temperature is correct for each climate classification: each climate classification:

Climate classification		ffor an ambient temperature of


SN		+10 bis +32 ¡C

N		+16 bis +32 ¡C

ST		+18 bis +38 ¡C

T		+18 bis +43 ¡C

30

Image 7

Contents …KO Santo Dear customer Contents Prior to initial startÐup SafetySafety of children Intended useCase of malfunction Daily OperationDisposal of old Appliances Remove transport safeguardDisposal Appliance Packaging InformationInstallation Location InstallationRehingeing the door Your appliance needs airLeft opening Housing dimensionsInstructions for total built-in Apply covers B on joint cover lugs and into hinge holes 50mm Fix cover D on guide B until it clips into place Electrical Connection Prior to Initial StartÐUpSetting ã0Ò means Off Starting up and temperature regulationAdjusting the upper door rack Interior AccessoriesStorage shelves Freezing and storing frozen food Fresh food refrigerationIce pack Preparation of Ice Cubes Storage Goods Symbols/Freezing CalendarDefrosting Switching off the appliance Cleaning and Care What to do if Energy Saving TipsCorrecting Malfunctions Remedy Changing the light bulb Regulations, Standards, Guidelines Customer Service2222