Product Model Numbers

30" (76 cm) Freestanding Electric Range

GFE461LV WFE366LV

GFE471LV WFE371LV

WFE301LV WFE374LV

WFE361LV WFE381LV

WFE364LV

Electrical: Range must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located behind the control panel or on the oven frame

PRODUCT DIMENSIONS

behind the storage drawer panel. Refer to the figures in the “Product Dimensions” section.

This range is manufactured with the neutral terminal connected to the cabinet. Use a 3-wire, UL listed, 40- or 50-amp power supply cord (pigtail). If local codes do not permit ground through the neutral, use a 4-wire power supply cord rated at 250 volts, 40 or 50 amps and investigated for use with ranges.

A circuit breaker is recommended.

The range can be connected directly to the circuit breaker box (or fused disconnect) through flexible or nonmetallic sheathed, copper or aluminum cable.

A. 27¹⁷⁄₃₂" (69.9 cm) max. depth with handle

B. 46⁷⁄₈" (119.1 cm) overall height (max.) with leveling legs screwed all the way in*

C. 36" (91.4 cm) cooktop height (max.) with leveling legs screwed all the way in*

D. 29⁷⁄₈" (75.9 cm) width E. 25" (63.5 cm) depth

F. Model/serial rating plate (located on the left side frame behind storage drawer panel)

*Range can be raised approximately 1"

(2.5 cm) by adjusting the leveling legs.

CABINET OPENING DIMENSIONS

Cabinet opening dimensions shown are for:

25" (63.5 cm) countertop depth, 24" (61 cm) base cabinet depth, 36" (91.4 cm) countertop height

A. 13" (33.0 cm) max. upper cabinet depth B. 30" (76.2 cm) min. opening width

C. For minimum clearance to top of cooktop, see NOTE*. D. 30¹⁄₈" (76.5 cm) min. opening width

E. Outlet - 8" (20.3 cm) to 22" (55.9 cm) from either cabinet, 5¹⁄₂" (14.0 cm) max. from floor

F. ⁷⁄₈" (2.2 cm) min. required between cutout and cabinet door or hinge.

*NOTE: 24" (61 cm) min. when bottom of wood

or metal cabinet is protected by not less than 1/4" (6.4 mm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

30" (76.2 cm) min. clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation	Ref. W10196158
Instructions packed with product. Specifications subject to change without notice.	07-30-08