Audiovox ACC56M owner manual USE of the CD Magazine, Loading Disc Into The Magazine

USE OF THE CD MAGAZINE

Loading Disc Into The Magazine

This CD Changer uses a specially-designed maga zine to hold up to 10 compact discs. To load discs into the magazine, grip the tab on the magazine tray into which you will be loading a disc and pull it out gently as shown in Figure 1. Pull out only one tray at a time. Insert a disc into the tray with the label side down (play surface facing up) as shown in Figure 2. Push the tray back into the magazine as shown in Figure 3. Load discs into the remaining 9 trays in a similar manner.

Removing Discs From The Magazine

To remove a disc from the magazine, pull out the tray of the disc to be removed, lift out the disc, and push the tray back into the magazine.

NOTES :

●Avoid touching the playing side of the disc.

●Only one disc can be inserted into each tray of the magazine. Do not try to insert more than one disc into each tray as damage to the discs and magazine may occur.

●This changer is not designed to play 3" CD-5 Single discs(8cm). Inserting a 3" disc into the magazine, either with or without a 3"disc adaptor, can damage the changer and the disc. Such damage will not be covered by the Warranty on this product.

●For additional CD magazines, you may contact us at www.asaelectronics.com

Fig. 1

Fig. 2

Fig. 3

Loading The Magazine Into The Changer

Completely slide the door on the changer to the right as shown in Figure 4. Making sure the top of the magazine is facing upward,gently insert it into the unit until it clicks into place, as shown in Figure 5. Slide the door of the changer fully closed and the unit is ready for operation.

Removing The Magazine From The Changer

The magazine can be removed from the changer using one of two methods as outlined below in steps 1 and 2.

NOTE: Be sure to keep the door on the changer closed at all times when not loading or removing the magazine. Leaving the door open could allow dust, dirt and moisture to enter the changer which could cause the unit to malfunction.

1.During normal operation with power applied, slide open the door on the changer and press the eject button as shown in Figure 6. The magazine will eject and can be removed.

2.If the magazinewill not ejectin a normal manner, remove power by disconnecting the DIN cable from the changer.

a.Slide open the magazine door. On the bottom left rear of the changer, as shown in Figure 5, peel off the tape covering the access hole; insert a thin-bladed screwdriver into the access hole and engage the mechanical release arm.

b.Lightly leverage the blade to the right and the magazine will disengage and be ejected.

Fig. 4

Fig. 5

Manual magazine release

(bottom left corner)

Fig. 6

Eject button

12 13