Audiovox 128-4874A installation instructions FORD-LINCOLN-MERCURY Installation 1985 and Newer

Page 6

FORD-LINCOLN-MERCURY INSTALLATION - 1985 AND NEWER

Important-This installation is designed for most 1985 through 1990 U.S. made Ford cars, and vans and an installation kit is required for these vehicles. See Kit Listing on Page 1 of this manual or refer to the in-store application chart. For 1991 and newer vehicles, the radio can be installed as shown on Page 2 of this manual or you can use the AX-88-SNP kit. Instructions for use of the AS-88-SNP kit are included with the kit and are not shown in this manual.

1.Remove the Existing Radio:

A.Remove existing dashboard trimpanel surrounding the radio opening. This panel is usually secured by screws and/or snap-in clips.

B.Remove the screws used to secure radio to the sub-dashboard.

C.Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.

D.Un-plug the wiring harness(es) and antenna cable and remove the radio.

2.Install the New Radio:

A.Follow the instructions included with the installation kit to attach the radio to the mounting plate supplied with the kit.

B.Place the radio near the dashboard so the wires can be led through the opening and following the instructions of Step 2 on Page 2 and diagram on Page 8, carefully wire the radio making certain all connections are secure and insulated and confirm proper operation.

C.Install the radio/mounting plate assembly to the sub-dashboard according to instructions of installation kit.

D.Attach one end of the perforated support strap (supplied) to the screw stud on the radio using the hex nut provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above or

below the radio using the screw and nut provided. Bend the strap to position it as necessary. CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from

the weight of the radio or improper operation of the radio due to vibration.

E.Replace the dashboard trimpanel.

F.Install knobs on radio shafts.

PERFORATED STRAP

HEXNUT

HEXNUT

IMPORTANT

AMOUNTING KIT IS REQUIRED

FOR THIS INSTALLATION

HELP!

1-800-645-4994

SCREWSTUD

Monday-Friday 8:30am - 7:00pmEastern

Saturday 9:00am-5:00pmEastern

RADIO

MOUNTING PLATE FROM KIT (NOT INCLUDED WITH RADIO)

SCREW

SHAFTNUTS

EXISTING DASH TRIMPANEL

-6-

Image 6
Contents Installation Instructions for Stereo Systems Mounting the Radio Wire the Radio to the Vehicles WiringInspect the Existing Radio Opening SaturdayOlder Wire the New RadioInstall the New Radio Remove the Existing RadioInstallation 1982 and Newer FORD-LINCOLN-MERCURY Installation 1984 and Older Install the New RadiioFORD-LINCOLN-MERCURY Installation 1985 and Newer Monday-Friday 830am 700pmEastern Saturday 900am-500pmEasternCHRYSLER-DODGE-PLYMOUTH Installation ALL U.S. Made CARS, TRUCKS, and Vans Built SinceMonday-Friday 830am 700pmEastern Wiring Diagram