Whirlpool SFOlOESR/ER manual Oven Vent, Lighting Standing Pilots, To light Cooktop Pilots

Page 9

The Oven Vent

Hot air and moisture escape from the oven through a vent located under the backguard. Do not block vent. Poor baking will result.

OVEN VENT

Lighting Standing Pilots

To light Cooktop Pilots:

1.Remove the surface burner grates from the cooktop. Lift the cooktop and rest on support rod.

2.Make sure all controls are OFF.

To light Oven Burner Pilot:

1.Make sure the Oven Temp Control is OFF.

2.Remove the broiler drawer. Slide drawer out to stops, liff both sides, then slide the rest of the way out.

3.To Ilght, hold a lit match over the pilot light located between the front and back burners. The pilot flame should be Y4to % in (.635-,953 cm) high.

4.If the pilot flame needs adjust- ment, turn the pilot adjustment screw on the manifold pipe.

5.Lower the cooktop and replace the grates before using the sur- face burners.

Hold a lit match over the oven burner pilot located at the rear of the burner.

After the oven burner pilot is burn- ing steady, check burner lighting by turning the Oven Temp Control to a temperature above 140°F (60°C). The burner will take 50-60 seconds to light.

Replace the broiler drawer.

9

Image 9
Contents GAS Range Before you use your range ContentsSafety Instructions Copy your Model and Serial Numbers here SAW These InstructionsModels SFOlOOSR/EF and Sfoioesrier Parts and featuresUsing your range Using the Surface BurnersCase of a Prolonged Power Failure Baking Using the Oven ControlBroiling Lighting Standing Pilots Oven VentTo light Cooktop Pilots To light Oven Burner PilotControl Panel Caring for your rangeLift-Up Cooktop Surface Burner GratesStandard Oven Cleaning Cleaning ChartUsing Foil Part What to USE For Assistance If you need service or assistanceLf you have a problem If you need service