Install Range

3-Wire Cable from Home Power Supply

IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection.

A
B
C	G
	H

A. Cable from home power supply	F. 4-wire flexible cable from
B. Junction box	range
C. Black wires	G. Red wires
D. White wires	H. UL listed wire connectors
E. Green (or bare) ground wire	I. UL listed or CSA approved
(from range)	conduit connector

1.Connect the 2 black wires (C) together using a UL listed wire connector.

2.Connect the 2 white wires (D) and the green (or bare) ground wire (of the range cable) using a UL listed wire connector.

3.Connect the 2 red wires (G) together using a UL listed wire connector.

4.Install junction box cover.

1.Using 2 or more people, lift range partially into cabinet cutout using the oven opening as an area to grip.

NOTE: Push against seal area of oven front frame when pushing range into cabinet. Do not push against outside edges.

2.Push against seal area of front frame to push range into cabinet until shipping feet almost contact cabinet.

A. Shipping foot

3.Use a Phillips screwdriver to remove and discard shipping feet.

4.Push range completely into cabinet and center range in cabinet cutout.

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Securely attach mounting screws to cabinet.

Reattach mounting screws if the range is moved.

Failure to follow these instructions can result in death or serious burns to children and adults.

5.Securely fasten range to cabinet using the two #8–14 x 1" screws provided. Insert the screws through holes in mounting rails. Do not overtighten screws.

A. Two #8–14 x 1" screws