INSTALLATION AND HOOK-UP
1. Cut mounting hole in desired location using mounting hole diagram (right).
2.Route power, speaker, and antenna cables through hole and connect to unit as shown below.
3.After making sure connections are correct, test unit operation as described in operation section.
4.For best AM reception, AM trimmer must be adjusted.
12 PIN FEMALE CONNECTOR WIRING COLOR CODE
FOR
COLOR | FUNCTION |
ORANGE/WHITE | +12VDC IGNITION HOT |
BLACK/WHITE | GROUND |
WHITE | A SPEAKER LEFT (+) |
VIOLET | A SPEAKER LEFT |
BLUE | A SPEAKER RIGHT (+) |
LIGHT GREEN | A SPEAKER RIGHT |
RED | B SPEAKER LEFT (+) |
VIOLET/BLACK | B SPEAKER LEFT |
YELLOW | B SPEAKER RIGHT (+) |
LT.GREEN/BLACK | B SPEAKER RIGHT |
Notes:
-When hooking up two speakers, hook A+ and A- speaker wires to speaker select A speaker on switch. A & B and B will not have any output at this time.
-B speakers are optional
-Speakers must have a minimum of four ohm impedance each.
-Either antenna may be used. Both do not have to be hooked up at the same time.
-Do not operate this unit with only one speaker hooked up. If a speaker fails, replace it before operating this unit.
NOTE: Always be sure when running cables to avoid sharp edges, extreme heat sources, and any other potential hazards. 2