Before You Call For Service
If you are having an operating problem, check the chart to see what the cause might be before you call for assistance.
OPERATING PROBLEM Nothing operates.
Oven will not operate.
Burner fails to light.
Burner flames are uneven.
Burner flames lift off ports, are yellow, or are noisy when turned off.
Burner makes popping noise when on.
CHECK IF
‘Range is properly connected to gas and electrical supplies.
. Fuse has blown or circuit breaker has tripped.
. Control knob is set in the correct position.
1The flow of combustion and /or venti- lation air to the range is blocked.
.The electronic controls are set cor- rectly. See pages
.YOU have programmed a delay start time.
. Range is connected to electrical power.
nFuse has blown or circuit breaker has tripped.
.Burner ports are clogged.
. Burner ports are clogged.
n Burner is wet from washing.
WHAT TO DO
mReconnect range to gas and/or electrical supplies. (See Installation Instructions.)
. Replace fuse or reset circuit breaker. In case of prolonged power failure, manually light burners (see page 4).
mSet control knob correctly, if needed.
1Remove blockage to air flow to and around range.
. Reset controls, if necessary.
1Reconnect range to electrical supply. (See Installation Instructions.)
. Replace fuse or reset circuit breaker. In case of prolonged power failure, manually light burners (see page 4).
1Clean with a straight pin (see pages 9 and 12)
. Clean with a straight pin (see pages 9 and 12) If this fails, call an authorized RoperSMservice technician for service.
1Contact an authorized RoperSMservice technician to check air/gas mixture.
1Let dry.
Continued on next page
Page 14