Hot air and moisture escape from the oven through a vent located under the backguard. The vent is needed for air circulation. Do not block the vent. Poor baking will result.
The storage drawer
The storage drawer is for storing pots and pans. The drawer can be removed to make it easier to clean under the range, and to check for installation of the anti- tip bracket(s). Use care when handling the drawer.
Removing the storage drawer:
Replacing the storage drawer:
Ball bearings
Burn Hazard
When the oven is ON, pans and pan handles left near the oven vent can become hot enough to burn the user and to melt plastics. Use potholders to move pans. Never store plastics, paper or other items that could melt or bum near the oven vent, or any of the surface burners.
Lever
1.Empty drawer of any pots and pans before removing drawer. Pull drawer straight out to the stop.
2.Push up black plastic lever on both sides of drawer.
3.Pull drawer out a little farther until levers stay in “up” position. Pull drawer the rest of the way out.
1.Make sure ball bearings on oven slide rail are positioned toward the front of the opening.
2.Fit ends of drawer slide rails into the oven slide rails on both sides of opening.
3.Slide drawer closed.
To verify that the anti-tip bracket(s) is engaged:
. Remove storage drawer.
. Look to see if the
. Make sure rear leveling leg(s) is positioned under bracket(s).
. See “Important Safety Instructions” on page 2 and Installation Instructions for further details.
NOTE: The range will not tip during normal use. Tipping can occur if excessive force or weight is applied to open door without
Page 8