Whirlpool FGS385Y Lift-up cooktop, Burners, Replace reflector pans and surface burner grates

Page 23

Lift-up cooktop

1.Remove surface burner grates and reflector pans.

2.Lii front of cooktop at both front corners until the support rods lock into place.

l

l

Personal Injury and

Product Damage Hazard

Be sure both support rods are fully extended and in the locked position. Failure to do so could resuft in personal injury from the cooktop accidentally falling.

Do not drop the cooktop. Damage can result to the porcelain and the cooktop frame.

3.Wipe with warm, soapy water. Use a soapy steel-wool pad on heavily soiled areas.

4.To lower the cooktop, lift cooktop from both sides while pressing the support rods back to unlock them. Lower the cooktop into place.

Replace reflector pans and surface burner grates.

Surface

burners

 

1. Lift up the

cooktop, following the instructions

Screws

above.

 

 

2.Before cleaning, remove screws that hold each of the burners in place. The screws prevent the burners from wobbling around during shipment. Remove the shipping screws with a Phillips screwdriver and lift the burners up and out. This separates the burners from the mounting bracket under each burner pair.

3.Wipe off surface burners with warm, soapy water and a sponge after each use. To remove cooked-on food, soak the burners in a vinegar and water solution for 20-30 minutes. Scrub with a plastic scrubbing pad.

4.lf ports are clogged, clean with a straight pin. DO NOT enlarge or distort the ports. DO NOT use a toothpick to clean the ports.

23

Image 23
Contents UseAndCare Thank you for buying a Roper appliance Your safety is important to usSee Installation Instructions General Important Safety InstructionsKeep range vents unobstructed When using the cooktopWhen usincl the oven GreaseCare and cleaning Right Front Parts And FeaturesControl Panels This Section Using Your RangeUsing the surface bur lners Burner heat settingsCookware tips Case of a prolonged power failureFood Positioning racks and pansHome canning information 6th oven rack position Roasting rackFor best air circulation Using the Minute Timer Setting the clockBaking/roasting Broiling Adjusting the oven temperature controlBroiling tips Rack ChartEnergy saving tips RackTo delay start and stop automatically Using the automatic Mealtimer clockBurn Hazard Oven ventTo start baking/roasting now and stop automatically Anti-tip bracket Storage drawerBefore you start Using The Self-Cleaning CycleHow the cycle works Remove any pots and pans being stored in the oven Setting the controlsClean Special tips To stop the Self-Cleaning cycle at any timeSurface burner grates and reflector pans Caring For Your RangeSurface burner grates and reflector pans Lift up Cooktop, following the instructions Lift-up cooktopBurners Replace reflector pans and surface burner gratesPart Cleaning chartHOW to Clean What to USE Surface burnersOven racks Oven door glass Oven cavity Oven light Before calling for assistance If You Need Assistance Or ServiceProblem SolutionCause For further information, write to Mr. William Clark If you need serviceIf you are not satisfied with how the problem was solved If you need assistancePage Page What WE will not PAY for Gas Cooking Product WarrantyLength of Warranty What WE will PAY for