STORAGE DRAWER (on some models)
Make sure drawer is cool and empty before cleaning.
For more information, see “Storage Drawer” section.
Cleaning Method:
■Mild detergent
Drawer Liner (on some models)
Remove all stored items from drawer and lift out drawer liner.
■Clean with mild detergent
■
See “Assistance or Service” section to order.
WARMING DRAWER and TRAY (on some models)
Make sure drawer is cool and remove tray.
Cleaning Method:
■Mild detergent (for both)
■
See “Assistance or Service” section to order.
Oven Door
For normal range use, it is not suggested to remove the oven door. However, if removal is necessary, make sure the oven is off and cool. Then, follow these instructions. The oven door is heavy.
Before Removing:
1.Use a putty knife or screwdriver and insert it at the bottom corner of the door stop clip.
2.Pry door stop clip free and remove from front frame hinge slot. Be certain not to scratch finish.
3.Repeat procedure for other door stop clip.
To Remove:
1.Open the oven door. Insert door removal pins, included with your range, into both hinge hangers. Do not remove the pins while the door is removed from the range.
2.Slowly close the door until it rests against the door removal pins.
3.Grasp the door on the sides with your fingers on the front of the door and your thumbs on the inside surface.
4.Pull door straight up, then toward you. Hinge hangers will slide out of front frame hinge slot. Do not remove door removal pins until the door is replaced on the range.
To Replace:
1.Grasp the door on the sides with your fingers on the front of the door and your thumbs on the inside surface.
2.Hold oven door so that the top edge of each hinge hanger is horizontal. Insert hinge hangers into the front frame hinge slots.
3.Tilt top of door toward range. Slide hinge hangers down onto front frame support pins. Make sure the hinge hangers are fully seated and engaged on the support pins.
4.Insert the door stop clip with the angular surface at the top of the frame hinge slot, then push in the bottom of the clip until flanges are flush with the front frame.
5.Open the door completely and remove the door removal pins. Save door removal pins for future use.
6.Close the door.
12