Whirlpool IGS365RS0 manual Electronic Oven Controls

ELECTRONIC OVEN CONTROLS

Style 1 - Electronic Oven Controls (on some models)

A

L K J I

A.Display

B.Timer

C.Clock

D.Oven light pad (on some models)

E.Cancel

F. Start (control lock)

B C D

HG F E

G. Hour/minute (on some models)

H. Timed cooking

I.Temperature

J.Auto clean

K.Custom broil

L.Bake

Start or Start/Enter

The Start or Start/Enter pad begins any oven function. If the Start or Start/Enter pad is not pressed within 5 seconds after pressing a function pad, the “START?” indicator light will flash as a reminder. On some models, “START?” will appear on the display.

Depending on your model, if Start or Start/Enter is not pressed within 1 minute or 5 minutes after pressing a function pad, the oven display will return to the time of day mode and the programmed function will be canceled.

Cancel or Off/Cancel

The Cancel or Off/Cancel pad stops any function except the Clock, Timer and Control Lock.

Clock

This is a 12-hour clock and does not show a.m. and p.m.

Style 2 - Electronic Oven Controls (on some models)

AB C D E F

K	J	I	H	G
A. Oven display				G. Temperature/time
B. Clock				H. Cook time
C. Timer/cancel				I. Start time
D. Start/enter (control lock)				J. Custom broil
E. Auto clean				K. Bake
F. Off/cancel

Display

When power is first supplied to the appliance, “PF” or a flashing time will appear on the display. Press CANCEL or OFF/CANCEL to clear “PF” or flashing time from the display.

If “PF” or flashing time appears, a power failure has occurred. Press CANCEL or OFF/CANCEL and reset the clock if needed.

When the oven is not in use, the display shows the time of day.

When performing a timed cook function, the display will show either hours and minutes, or minutes and seconds.

To Set:

Before setting, make sure the oven and Timer are off.

1.Press CLOCK.

2.Depending on your model, press the HR or MIN or TIME/ TEMP “up” or “down” arrow pads to set the time of day.

3.Press CLOCK or START.

Tones

Tones are audible signals, indicating the following:

One tone

■Valid pad press

■Oven is preheated (long tone)

■Function has been entered

■Reminder, repeating each minute after the end-of-cycle tones

Three tones

■Invalid pad press

Four tones

■End of cycle

Reminder Tones: Reminder tones may be turned off. On some models, press and hold STOP TIME for 5 seconds. “rEP OFF” or “off” will appear in the display. Repeat to turn reminder tones back on, and “rEP on” or “on” will appear in the display.

All Tones: All of the above tones are preset on, all except the end-of-cycle tones can be turned off.

To Turn Off/On (on some models): Press and hold START TIME for 5 seconds. A tone will sound, and “Snd OFF” will appear on the display. Repeat to turn tones on, and “Snd on” will appear on the display.

On some models, only the loudness of the tones can be adjusted. On other models, the tones cannot be adjusted or turned off.

Tone Pitch: The pitch is preset at high, but can be changed to low. On some models, only the loudness of the tones can be adjusted. On other models, the tones cannot be adjusted or turned off.

To Change (on some models): Press and hold BAKE for

5 seconds. A tone will sound, and “Snd LO” will appear on the display. Repeat to change, and “Snd Hi” will appear on display.

8