Isotemp Laboratory and Chromatography Refrigerators | Page 2 of 12 |
|
|
Installation
Selecting a Location
Leveling the Unit
Door Handles
Door Removal and Adjustment
Part Number: 104416
Choose a location for the refrigerator that will provide at least three inches of clearance between the cabinet and any adjacent vertical surface at the sides and rear. Appropriate electrical power must be available. Locate the refrigerator within 6 feet of the power outlet so that no extension cord is required.
The refrigerator must be level in order to provide adequate condensation drainage as well as proper door alignment and operation. The refrigerator should be in its final operating location and set so that it is firmly positioned on the floor. There are four leveling screws, one on each corner. . Level the cabinet front to rear and side-
1.Remove the lower grille attaching screws.
2.Grasp the grille with both hands.
3.Tilt the lower end of the base grille toward you.
4.Pull grille away from the refrigerator
(Swinging Door Models Only)
Door handles are packed inside each refrigerator. To mount the handle, lift the door gasket behind the two screws on the front of the door. Attach handle with offset away from the cabinet corner and tighten the screws.
(Sliding Door Models Only)
Each door has its own closing spring located at the top of the door track. Each spring is set for proper tension. If adjustment is required:
1.Check for cabinet level (see above).
2.Remove the door(s) by lifting it and sliding about half way open. The roller will fall into a gap in the upper track. While maintaining upward pressure on the door, pull the bottom outward until it clears the bottom track.
3.Adjust the location of the door rollers in the roller brackets (above door) as shown by loosening the lock nut on the back of the roller bracket and moving the roller up or down.
Closing spring
Lock nut on back 
Roller
Fig. 1